Adtran SDX810RG User Manual

Wall mount Installation Steps

To install the SDX810-RG, refer to Figure 6 and
complete the following steps.

NOTE

Do not mount the SDX810-RG above three meters
from the floor.

Wall Mount Installation

To wall mount the SDX810-RG, complete the
following steps:
Refer to Figure 6 when installing the SDX810-RG
on a wall.

1. Determine a location for the SDX810-RG.

Figure 6. Wall Mount Keyholes

2. Use the key holes on the back of the
SDX810-RG as a template and install two #6
drywall anchors.

3. Install two Ø 3.5*30L Pan Head screws. Leave

approximately 1/4-inch (0.6 cm) protruding from
the mounting surface. Refer to Figure 7.

F

Figure 7. Place Ø 3.5*30L Screws

4. Slide the SDX810-RG over the Pan Head
screws and exert a small amount of downward
pressure to ensure that the top of the slots are
resting on the shafts of the Pan Head screws.