Acurite 06074 User Manual

Battery Pack for AcuRite® Atlas
TM
Model 06074:
REMOVE BATTERY COMPARTMENT COVER
1. Remove battery compartment cover from the bottom of the AcuRite
®
AtlasTM outdoor device.
Remove batteries if currently installed.
INSTALL BATTERIES
INSERT BATTERY PACK CORD
2. Plug the battery pack cord into the battery compartment AcuRite
®
AtlasTM.
REPLACE COVER
LOOP CORD AND REPLACE BATTERY COMPARTMENT COVER
3. Loop the cord through the slot, then replace the
battery compartment cover.
MOUNT BATTERY PACK
REMOVE BATTERY PACK COVER
4. Remove the battery pack cover by pulling upward on the cover’s tabs (away from the battery pack).
SECURE CABLE
5. Insert 4 x AA alkaline or lithium* batteries into the battery compartment. Heavy duty or rechargeable batteries are not recommended.
6. Replace the battery pack cover.
7a. Mount the battery pack using the integrated
hang holes. We recommend mounting on a pole or a flat surface such as a wall or post. The battery pack is water-resistant and is designed for general outdoor use.
* Cold temperatures can cause alkaline batteries to function improperly. Use lithium batteries for temperatures below -4°F (-20°C).
7b. Use the included zip ties and hardware to
secure excess cable near the battery pack, leaving enough slack for a “drip-loop,” preventing rain water from trailing into the battery pack. Installation is complete.
QSG17_06074 082817
Loading...