Display for 5-in-1 Weather Sensor
Package Contents
1. Display unit with tabletop stand
2. Power adapter
3. Instruction Manual
Instruction Manual
model 06007RM/1015RX
This product requires an AcuRite 5-in-1 Weather Sensor (sold separately) to be
operational.
PRODUCT MUST BE REGISTERED
IMPORTANT
PRODUCT REGISTRATION
Register online
to receive 1 year
warranty protection
www.AcuRite.com
TO RECEIVE WARRANTY SERVICE
Register a Product
►
Questions? Contact Customer Support at
(877) 221-1252 or visit www.AcuRite.com.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
1. Peak Wind Speed
Highest speed from past 60 minutes.
2. Average Wind Speed
of all speeds from past 2 minutes.
3. Learning Mode Icon
Disappears after weather forecast
self-calibration is complete.
4. Weather Select
Heat index, dew point, wind chill,
indoor temperature / humidity,
rainfall rate (in/mm per hour).
5. “u“ Button
Press to change the Weather Select
category data being displayed.
6. 12 to 24 Hour Weather Forecast
Self-Calibrating Forecasting pulls
data from the outdoor sensor to
generate your personal forecast.
7. 5-in-1 Sensor Signal Strength
8. Alarm On/Off Indicator
for Selectable Category (#22).
9. Programmable Alarm Settings
10. “ “ Icon
Indicates active Weather Ticker message
during ticker customization mode.
11. “ “ Icon
Indicates deactivated Weather Ticker
message during ticker customization
mode.
12. ALARM On/Off Button
Activate alarm; press and hold to
adjust alarm values.
13. “ “ Button
remove
Press to deactivate Weather Ticker
message.
14. “▲/▼“ Buttons
Select Category (shown in #22) &
Adjust Settings.
15. “SET“ Button
16. “ “ Button
Press to advance through Weather
Ticker messages.
17. “HISTORY MODE“ Button
Press for all-time low and date
recorded for current category
selected on display (#22). Press twice
for all-time high and date recorded.
18. “ “ Button
add
Press to activate Weather Ticker
message.
19. Weather Ticker™
20. Record Low
Shown for current category selected
on the display (#22).
21. Record High
Shown for current category selected
on the display (#22).
22. Selectable Category
23. Clock
24. Date
25. Current Month Total Rainfall
26. All-Time Total Rainfall
27. Current Barometric Pressure
FALLING, STEADY, or RISING
indicates direction pressure is
trending.
28. Rain Alarm On Indicator
29. Current Rainfall
Accumulates data during rainfall.
30. Storm Alert Alarm On Indicator
31. Outdoor Humidity Alarm On
Indicator
32. Current Outdoor Humidity
Arrow icon indicates direction
humidity is trending.
33. Outdoor Temperature Alarm On
Indicator
34. Current Outdoor Temperature
Arrow icon indicates direction
temperature is trending.
35. “CAL“ Icon
Indicates calibrated value is
being displayed.
36. Wind Speed Alarm On Indicator
37. Current Wind Speed
38. Touch Activated Backlight
Momentary during battery power,
always on/off with power adapter.
39. Previous 2 Wind Directions
40. Current Wind Direction
3
Back of Display Unit
1
2
3
4
5
6
7
Display Unit Setup
Set the A-B-C Switch
1
The A-B-C switch is located inside
the battery compartment. It can
be set to A, B or C. However,
you must select the same letter
choices for both the sensor and
the display unit in order for the
units to synchronize.
BACK OF DISPLAY UNIT
1. Integrated Hang Hole
For easy wall mounting.
2. Plugin for Power Adapter
3. A-B-C Switch
ID code that must match
5-in-1sensor’sA-B-Cswitch
to ensure units synchronize.
4. CLEAR TODAY Button
Clears data recorded since
12:00am.
5. CLEAR ALL Button
Clears all recorded data without
having to reset time and date.
6. RESET Button
Full reset to factory defaults.
7. Battery Compartment
8
8. Power Adapter
9. Battery Compartment Cover
(not shown)
Plug Power Adapter into
2
Electrical Outlet
Install or Replace Backup
3
Batteries
(optional)
A B C
1
set to match sensor
A-B-C Switch
Plug in Power
2
Adapter
4