AcuRite 06003RM, 5N1DSSA Instruction Manual

5-in-1 Sensor Pro Add-On

model 06003RM/5N1DSSA

WHAT YOU NEED:

• 5-in-1 sensor

• Spray lubricant

• Phillips head screwdriver

The Pro Add-On with dual solar panels for the 5-in-1 sensor optimizes the
sensor’s sun exposure, allowing the sensor’s solar-powered aspirating fan to run
more often. The sensor’s internal fan helps to optimize the measurement of the
temperature throughout all hours of the day.

The AcuRite 5-in-1 sensor features a modular design that allows for the
replacement of certain parts. The electronic components inside the 5-in-1 sensor
are sensitive - HANDLE WITH CARE.

NOTE: A 5-in-1 sensor is required to install the Pro Add-On.

5-IN-1 SENSOR PRO ADD-ON

INSTALLATION

Prior to installtion of the Pro Add-On, remove
batteries from the 5-in-1 sensor to avoid
erroneous data while handling and

REMOVE 4 SCREWS

1. Remove 4 LONG screws and separate 2. Set aside the lower gray portion of 3. Remove 4 SHORT screws, located on the upper white
the upper white portion from the lower the sensor and the screws for portion of the sensor near the fan assembly.
gray portion of the sensor. reassembly. Keep the screws for reassembly.

transporting the sensor.

Scan QR code

to view a video.

TO LUBRICATE:

1. Remove screw located below sensor’s
wind cups. Keep the screw for step 4.

2. Spray a small amount of lubricant into
the hole.

3. Tip the 5-in-1 Sensor upside down (so
wind cups are on the bottom), then
right side up several times.

4. Reinsert the screw (removed during
step 1) into hole.

REMOVE 4 SCREWS

SET
ASIDE

REMOVE & DISCARD INSTALL

PRO ADD-ON

DISCARD

KEEP!

4. Gently remove the upper 5. Line up the screw holes on the
wind speed / solar assembly from Pro Add-On with the rain gauge
the rain gauge assembly and discard. assembly.

06003RM 060914

REINSTALL 4 SHORT SCREWS

6. Turn the upper white portion of the sensor over.
Reinstall the 4 SHORT screws; tighten by hand.

REINSTALL 4 LONG SCREWS

7. Reinstall 4 LONG screws to connect the
upper white portion and lower gray portion
of the 5-in-1 sensor. Installation is complete!

www.AcuRite.com