Actiontec HPE400AVP Quick Start Manual

Step

1 Get the MegaPlug AV

200 Mbps Powerline Ethernet
Network Adapter from the box.

Step

2 Get one Ethernet Cable.

Step

3 Plug one end of the

Ethernet Cable into the Ethernet
Port on the bottom of the
MegaPlug Adapter.

Step

4 Plug the MegaPlug

Adapter into a Power Outlet.

Do NOT
power strip or wall outlet that uses
surge protection as the Adapter
may not work.

Step

Ethernet Cable into an OPEN
Ethernet Port on your Broadband

Modem or Router.

Step

200 Mbps 4-Port Switch from the
box. You will connect the 4 Port
Switch to the device(s) that you
want to have Internet access.

plug the Adapter into a

5 Plug the other end of the

6 Get the MegaPlug AV

Broadband
Router

Step

8 Plug one end of the

Power Cord into the back of the
MegaPlug 4-Port Switch.

Step

9 Plug the other end into a

Power Outlet.

Do NOT
power strip or wall outlet that uses
surge protection as the Switch
may not work.

Step

Ethernet Cable.

plug the Switch into a

10 Get the other

Note: An Ethernet port looks similar to a phone port but is slightly larger.

Questions? Call 1-888-436-0657 (USA) Questions? Call 1-888-436-0657 (USA) Questions? Call 1-888-436-0657 (USA)

Step

7 Get the Black Power

Cord.

Flip this Quick Start Guide over to continue

Part No:0530-0602-000 QS1024/0309

NEXT

Step

11 Plug one end of the

Ethernet Cable into an Ethernet
Port on the back of the
MegaPlug 4-Port Switch.

Step

12 Plug the other end of

the Ethernet Cable into the
device that you want to connect
to the Internet.

Model# HPE200AVP,

HPE400AVP

Congratulations!

Note: You can repeat Steps 10 thru 12 for each device that needs to be connected

to the Internet.

Step

13 Check the LEDs and

make sure both Link Lights turn
SOLID GREEN.

Note: This Quick Start Guide shows you how to install the 4-Port Switch in a
location apart from your router/gateway (another room for example). If you need
additional Ethernet ports near the router/gateway,you can reverse the installation
order of the Powerline units (i.e., install the 4-Port Switch first, then install the
MegaPlug Adapter in another room).

You have successfully installed the MegaPlug AV Powerline Ethernet
Network Adapter and 4-Port Switch.
These adapters ship with a generic encryption key.If you would
like to change the key, go to www.actiontec.com/howto for
further instructions.If you require additional adapters for additonal
computers/devices,they may be added by following the same
steps in this guide.

Questions? Call 1-888-436-0657 (USA)Questions? Call 1-888-436-0657 (USA)

Quick Start Guide

This Quick Start Guide will walk you through the easy

steps toinstall your MegaPlug™ AV Powerline Ethernet Kit.

You will need the following items:

One MegaPlug™ AV 200 Mbps

•

Powerline Ethernet Network Adapter
One MegaPlug™ AV 200 Mbps

•

4-Port Switch
Two Ethernet Cables

•

One Black Power Cord

•

NEXT