Actiontec HPE200AVP Quick Start Manual

Connect the Adapter to a PC or Modem/Router

1

Step

1 Get one MegaPlug AV

200 Mbps Ethernet Adapter from

the box.

Step

4 Plug the MegaPlug

Adapter into a Power Outlet.

Do NOT
power strip or wall outlet that uses
surge protection as the Adapter
may not work.

plug the Adapter into a

Step

2 Get one Ethernet Cable.

Step

3 Plug one end of the

Ethernet Cable into the Ethernet
Port on the bottom of the
MegaPlug Adapter.

Note: An Ethernet port looks similar to a phone port but is slightly larger.

Step

5 Plug the other end of the

Ethernet Cable into an OPEN
Ethernet Port on your Modem or

Router.

Step

6 Repeat Steps 1-5 for a

computer or an Internet device.

Flip this Quick Start Guide over to continue

Broadband
Router

NEXT

Questions? Call 1-888-436-0657 (USA) Questions? Call 1-888-436-0657 (USA)

Step

7 Make sure that the Link

light on each Adapter turns

SOLID Green.

Congratulations! You have successfully installed both MegaPlug
AV 200 Mbps Ethernet Adapters.

These adapters ship with a generic encryption key. If you would
like to change the key,refer to our website for further instructions.
If you require additional adapters for additonal computers/devices,
they may be added by following the same steps in this guide.

www.actiontec.com/howto

Model# HPE200AVP

Quick Start Guide

This Quick Start Guide will walk you through the

easy steps to install your MegaPlug™ AV 200 Mbps

Ethernet Adapters.

Connect theAdapter to a PC

1

or Modem/Router

You will need the following items:

Two MegaPlug™ AV 200 Mbps

•

Ethernet Adapters
Two Ethernet Cables

•

Part No:0530-0553-003 QS841/0806

Questions? Call 1-888-436-0657 (USA)

NEXT