Accurist OS60, OS10, OT10 Instruction manual

Caseback markings

w

MB 119

CAL 0T10

SR927W

Accurist Watches Logo
Model Number

Calibre Number

Battery Number

OS60, OS10 & OT10 Operating Instructions

Dial A

Top Left (TL) Top Right (TR)

Dial C

(hour dial)

(minute dial)

Dial B

(seconds dial)

Position A

Bottom Right (BR)Bottom Left (BL)

Position B Position C

To set the time:

1. Gently pull out crown to position C.

2. Turn crown either way to correct time.

3. Push in crown to position A.

To set the date:

1. Gently pull out crown to position B.

2. Turn crown anti-clockwise to adjust date.

3. Push in crown to position A.

Using the chronograph:

1. Press BR Button to put the watch in Chronograph mode.

Making sure all sub dials are zeroed. If not, refer to ‘Chronograph Zero Reset’.

2. Press TR Button to start and stop the chronograph

OS60, OS10 & OT10 Operating Instructions continued . . .

3. Press BR Button to reset the chronograph

4. When you have finished with the Chronograph function, press BR Button

again; this re-starts the small second hand on Dial B.

Note: After 30 seconds the Second hand on Dial B will stop at the zero position,
however, the time is still continuing to be measured in seconds and when TR
Button is pressed to stop the timing, the second hands will automatically move
to show the time.

Chronograph zero set:

This procedure is only necessary when the battery is replaced, or when the
Chronograph hands do not return to the ‘0’ position, when the Chronograph
mode is selected.

1. Gently pull out crown to position C.

2. Push TR Button to advance the sweep second hand to the 12 0’clock position.

Please note each push of the TR Button will advance the hand 1 second.
Alternatively, depress and hold the Button for 2 seconds and the hand advances
continuously.

3. Push BR Button; this automatically re-sets sub dials. Each subsequent push
will advance the Second hand on sub dials by 1 marking. Alternatively, depress
and hold Button for 2 seconds; the hand will advance continuously until released.

4. Push in crown to Position A.

FS60 Operating Instructions

Top Right (TR)

Chronograph
Minute Hand

Chronograph
Second Hand

Bottom Right (BR)

Date indicator

Day indicator

Position A

(The angle of this fanshaped
day indicator may vary from
model to model).

Position B Position C