2 eye and 3 eye chronograph
with date
A
SEC
MIN
1 2 3
B
A
1 2 3
24H
MIN
SEC
B
2 eye and 3 eye chronograph
with date
Resetting the chronograph function:
• Before setting the time please check that all
chronograph hands are at the “0”/12 o’clock
position.
• To reset the hands to the “0”/12 o’clock
position press the buttons on your watch in the
following sequence:
1. If the chronograph is counting then press ‘A’
to stop the chronograph and then ‘B’ to reset
back to “0”.
2. If split timing is displayed then press ‘B’ then ‘A’
followed by ‘B’ again to reset.
• Always push the crown back to position “1”
once the above has been completed.
* Instructions continued overleaf.
GUARANTEE
PLEASE USE BLOCK CAPITALS
NAME
ADDRESS
POST CODE
DAYTIME TELEPHONE NUMBER
IMPORTANT
This guarantee slip should be retained by the owner of
the product and should be sent to Timeproducts (UK)
Ltd. together with the product and £4.50 to cover the
handling and postage when service under Guarantee
is required.
Instruction Guide
and
2 year Guarantee
IA03
Your ACCURIST watch is guaranteed against defects in mate-
Service and Repairs
rials and workmanship for a period of 2 years from the date of
purchase. During this period, we will exchange or repair, at our
discretion, any defective components free of charge.
IMPORTANT - Not covered by Guarantee
1. Batteries, straps and bracelets.
2. Damage caused by accident, misuse or lack of care.
3. Water penetrations except in watches marked as “Water
Resistant”.
SERVICING AND REPAIRS UNDER GUARANTEE
Please post your watch, together with the Retailer’s Sales Receipt or proof of purchase, the completed Guarantee slip, and
a brief note to explain the nature of the fault, by Registered
Post or Recorded Delivery to the address shown. Do not send
the presentation box as this will NOT be returned.
SERVICING AND REPAIRS OUTSIDE OF GUARANTEE
Available at a reasonable charge after an estimate has been
sent by T.P. (UK) Ltd. Send your watch to us by Registered
Post or Recorded Delivery to the address shown.
Important Note
It is important to identify your watch correctly. If, after reading
this Instruction Guide, you have any further questions regarding the use, operation or adjustment of your watch, please call
us during oce hours on 0116 288 2500.
T.P. (UK) Ltd, Alexander House, Chartwell Drive, Wigston,
Leicester LE18 2EZ
United Kingdom.
Water Resistance
If your watch is water resistant, it will clearly state “Water
Resistant” or have a static water pressure indication (e.g.
“30/50/100/200 metres”) on the dial and/or case back.
If it is not marked as water resistant, it should not be allowed
to come into contact with water or be worn in conditions
that could expose it to moisture (e.g. washing, heavy rain
etc.). Certain chemicals in water may damage the watch
seals. To maintain water resistance, we recommend that your
watch is serviced and re-sealed at least every 12 months by
T.P. (UK) Ltd.
IMPORTANT
Buttons must not be operated while in contact with water.
WATER RESISTANT or RESISTANT TO 30 METRES
Suitable for normal everyday use and will resist exposure to
splashes and rain; it is NOT designed to be used whilst bathing
or swimming.
WATER RESISTANT TO 50 METRES
As 30 metres plus bathing or swimming.
WATER RESISTANT TO 100 METRES
As 50 metres plus pool side diving and snorkelling, but not
high board or scuba diving.
WATER RESISTANT TO 200 METRES
As 100 metres plus scuba diving, but not high board diving.
Accurist_IA03_SpotColour.indd 1-6 16/12/2014 15:19
HOUR
CHRONOGRAPH
SECONDS
3 eye chronograph
with day and date
A
MIN
REMOTE
SEC
B
1 2 3
3 eye chronograph
with day and date
Setting the time:
1. Pull the crown out to position ‘3’ and adjust the
hands to the desired time.
2. Push crown back to position ‘1’.
Setting the date:
1. Pull the crown out to position ‘2’.
2. Turn the crown anti-clockwise to set the date.
3. After the date has been set push the crown
back to position ‘1’.
* Do not attempt to set the date between 9:00 PM
and 1:00 AM as the date change cycle is already in
progress.
Setting the day:
1. Pull the crown out to position ‘2’ and turn the
crown clockwise until the desired day is set.
2. After the day has been set, push the crown
back to position ‘1’.
GUARANTEE
DATE OF PURCHASE:
Retailers stamp if required or full name and address:
Please attach the receipt or proof of purchase; failure to
attach these may invalidate this Guarantee.
This Guarantee does not aect your statutory rights.
IA03/12-2014
2 eye and 3 eye chronograph
with date
Setting the time:
* The chronograph measurement must be stopped
before the time can be set.
1. Pull the crown out to position ‘2’.
2. Turn the crown clockwise until the previous
date is displayed.
3. Now pull the crown out to position ‘3’ and
adjust the hands to the desired time.
4. Push crown back to position ‘1’.
* Do not attempt to set the date between 9:00 PM
and 1:00 AM as the date change cycle is already in
progress.
2 eye and 3 eye chronograph
with date
Using the stop watch/chronograph
feature:
* The chronograph measurement can time up to 60
minutes.
• Standard measurement:
1. Press ‘A’ to start the chronograph timing, then
press ‘A’ to stop the timing.
2. Press ‘B’ to reset the chronograph.
• Accumulated elapsed time measurement:
1. Press ‘A’ to start timing, then press ‘A’ to stop
the timing.
2. Restart the timing by pressing ‘A’ as many
times as required.
3. Press ‘A’ to stop the chronograph and ‘B’ to
reset.
2 eye and 3 eye chronograph
with date
Using the stop watch/chronograph feature continued:
• Split time measurement:
1. Press ‘A’ to start the timing, then press ‘B’ to
split the timing.
2. Press ‘B’ to release the timing as many times
as required.
3. Press ‘A’ to stop the chronograph timing.
4. Press ‘B’ to reset the chronograph.
* Do not attempt to set the day between 11.15 PM and
6.00 AM as the day/date change cycle is already in
progress.
* The chronograph measurement can time up to 4
hours, 59 minutes and 59 seconds.
Please refer to the previous chronograph sections
for function. Note that the ‘split time measurement’
function is not included for the ‘3 eye chronograph
with day and date’.
Accurist_IA03_SpotColour.indd 7-12 16/12/2014 15:19