Abocom FE2000VX User Manual

CardBus 10/100 Fast

Ethernet PC Card

Quick Installation Guide

HARDWARE INSTALLATION

1. Hold the CardBus PC Card with wide
connector toward the slot and the brand label
facing upward.

2. Insert the CardBus PC Card and push it firmly
into the bottom. (Please see the following
figure for reference)

Notebook

K
N
I
L

T

C
A
r

e

w
o
P

3. Connect the RJ-45 port of the CardBus 10/100
Ethernet PC Card Adapter to a Category 5
Network cable before loading any network
driver.

 For operation in the 100Mbps (100Base-TX)

Ethernet network, a Category 5 unshielded
twisted pair (UTP) cable should be used to
connect between the RJ-45 port and a 100Mbps
hub or switch.

 For operation in the 10Mbps (10Base-T)

Ethernet network, a Category 3, 4 or 5
unshielded twisted pair (UTP) cable could be
used to connect between the RJ-45 port and a
10Mbps hub or switch.

- 1 -

SOFTWARE INSTALLATION

Windows 95 Installation (OSR2 or later)

1. Boot up computer to Windows 95. Make sure
the CardBus 10/100 Fast Ethernet PC Card is
well connected to the CardBus Socket.

2. Click Next in the Update Device Driver
Wizard Windows.

3. Click Others Locations to select a driver
manually.

4. Insert the installation disk into the floppy disk
drive and type A:\ (Assumed A:\) to specify the
location of the installation driver. The driver
will be installed automatically.

5. Insert the original Windows 95 CD/disks to
reset the system as requested.

6. For the first installation, please select Network
in the Control Panel window to add Protocols,
Client and Service if needed.

7. Restart the system to activate the card.

- 2 -

Windows 98 Installation

1. Boot up computer to Windows 98. Make sure
the CardBus 10/100 Fast Ethernet PC Card is
well connected to the CardBus Socket.

2. The system will automatically detect the card
and ask for the device driver. Click Next to
continue.

3. Select Search for the best driver for your
device(Recommended) and click Next to
continue.

- 3 -