Aastra Telecom 41-001348-00 User Manual

6725ip Phone Quick Reference Card

Parts List

Phone

Handset

Front Panel

OK

OK/Navigation Key

Home Key

Voicemail Indicator

Back Panel

Handset

Keypad

Volume Down Key

Cord

Ethernet
Cable

Leg Slot Locations

USB Cable

Softkeys

OK

Mute Key

Telephone Base

Desk Legs

Incoming Call Light

Back Key

Unied Communications (UC)
Presence Logo

Headset Key
Speakerphone Key

Volume Up Key

Headset Jack Handset Jack

6725ip Phone
Documentation

Phone Requirements

• Microsoft Lync Server 2010

• LAN - 10/100/1000BaseT Ethernet, category 5/5E/6 straight through cabling

• Power source - IEEE 802.3af Power-over-Ethernet source or the Aastra 48V Power Adapter (Optional Accessory)

™

®

Setting up your phone

To connect the handset to the phone:

1. Connect one end of the handset cord (B) to the handset (A)

and the other end of the handset cord (B) to the handset jack
on the back of the phone (C).

2. Guide the cord through the channel on the back of the phone

to the outer edge (as shown in the “Back Panel” illustration).

To connect the legs to the phone:

A total of four dierent viewing angles allows you to
personalize your viewing preference.

1. Attach each leg by inserting the tabs on the leg into the slots

on the bottom of the phone. There are three pair of leg
slots on each corner of the phone (D).

2. For a higher viewing angle, use the second and third slots from the top.

3. For a lower viewing angle, use the rst and second slots from the top.

4. Push the stand towards the phone until it snaps into place.

To connect to the network:

1. Connect one end of the RJ-45 Ethernet cable (supplied)

into the port marked “LAN” on the base phone.

2. Connect the other end of the Ethernet cable into your

network source jack.

For Ethernet networks that DO NOT supply
Power-over-Ethernet to the phone:

1. Connect an Aastra 48V power adapter (optional accessory)

to the power port on the base phone and plug the other end
into a wall power outlet.

USB Port
Type A

A

B

D

USB Port
Type B

LAN

(connection not required if power

provided over Ethernet connection)

Ethernet
LAN Port

PC

48V Power Port

C

Ethernet
PC Port

(Optional) Connect the phone via USB

Handset Cord Channel

TM

to your computer

To connect the phone to your computer:

1. Connect the USB Type B connector on the USB cable (supplied)

to the Type B port on the base phone (see illustrtation above).

2. Connect the USB Type A connector on the USB cable to a USB port

on your computer.

USB Type B
connector
to phone

USB Type A
connector to
computer

41-001348-00 Rev 04