3sixt 3S-0332, 3S-0331, 3S-0330, 3S-0333 User Manual
QUICK START GUIDE
TREK Personal Bluetooth Speaker
Fully charge TREK for at least 2 hours through a
1
wall outlet before first use (see step ➋).
To recharge TREK
2
Insert the supplied USB 2.0 cable (micro USB
end a) into TREK’s 5V input port b. Insert USB
end of cable c into the USB 2.0 port of your
wall adaptor, laptop or PC d.
d
c
f
a
Pairing TREK for the first time with your device
3
Enable your device’s (eg. smartphone or tablet) Bluetooth.
Hold down the Power Buon
TREK on. TREK will automatically try to find your device.
e
The LED
will flash blue and TREK should then appear
in your device’s paired devices list. ‘Pair’ your device with
TREK. TREK will then make another tone to confirm the
pairing and the LED will stay blue to denote a connection.
You are now free to play music & audio through TREK.
Adjust the volume of TREK through your device’s volume
seings or the or buons g on TREK (long press).
For every pairing aer your first, you only need to turn
on your device’s Bluetooth, turn on TREK by holding
down the Power Buon
the ‘pairing successful’ tone. To operate speakerphone
function, press h to pick up or hang up an incoming call.
f
for 4 seconds to turn
e
for 4 seconds and wait for
Important Safety Information
d
e
h
g
b
PLEASE READ BEFORE OPERATION
1. Before recharging TREK through
a wall outlet make sure wall outlet
voltage is 5V.
2. Make sure to use a standard USB
2.0 Charge & Sync Cable with the
appropriate specifications - other
cables may damage your smartphone,
tablet or TREK.
3. Do not drop, knock, dissasemble or
aempt to repair TREK.
4. Do not immerse or put TREK in water
and keep TREK in a dry place.
5. Do not expose TREK to excessive heat
including sunlight and fire.
6. Do not use TREK near explosive gases
or flammable materials.
7. Do not burn or incinerate TREK.
8. Do not expose TREK to harsh
chemicals.
9. Turning TREK’s volume up to the max
shortens the life of TREK. It also may
damage your hearing.
10. Puing anything in TREK’s input or
output ports, other than a standard
USB 2.0 charge & sync cable will
cause damage or short out TREK.
11. When encountering any fault during
operation, please cut o the power
supply and disconnect the USB cable
to prevent further damage to the
speaker or other components.
12. The Bluetooth transmission range or
connectivity could be aected by low
baery power. In that case, recharge
immediately.
For more information visit www.3sixtgear.com/support
3S-0330/0331/0332/0333
Loading...