3M 9671 User Manual

Surgical Clipper with Fixed Head
Tondeuse chirurgicale à tête fixe
Medizinisches rasiergerät mit feststehendem scherkopf
Rasoio chirurgico ricaricabile clipper con testina fissa
Rasuradora quirúrgica con cabezal fijo
Chirurgische clipper met vaste kop
Kirurgisk klippapparat med fast huvud
Kirurgisk klipper med fast hoved
Kirurgisk clipper
Kkirurgiset karvanleikkurit kiinteällä päällä
Máquina eléctrica de tricotomia com cabeça fixa

ГВИЪФ˘ЪБИО‹ •˘ЪИЫЩИО‹ ªЛ¯·У‹МВ ™Щ·ıВЪ‹ §ÂÊ·Ï‹

9671

3

Clipper: Made in USA from Foreign and US Components
for 3M Health Care, St. Paul, MN 55144-1000
Charger: Made in China for 3M Health Care,
St. Paul, MN 55144-1000
Blade Assembly: Made in USA for
3M Health Care,
St. Paul, MN 55144-1000

3M Health Care

D-41453 Neuss, Germany

3M is a trademark of 3M
© 3M 2004 All rights reserved. 34-7057-8706-6

CAUTION

To reduce the risks associated with fire, and hazardous voltage, which if not avoided may result in minor or moderate injury and/or
property damage:

• Do not sterilize the clipper body, battery charger, or blade assembly.

• Only use attachments recommended by the manufacturer.

• Always store the clipper and cord in a moisture-free area.

• Do not attempt to replace the battery in the clipper.

• Do not charge the clipper outdoors.

• Keep cord away from heated surfaces.

• See rating plate on charger unit for proper wall outlet voltage.

To reduce the risk associated with environmental contamination, which if not avoided may result in minor or moderate injury:

• At the end of product life, dispose of all components in accordance with your governmental regulations.

To reduce the risks associated with skin nicks and lacerations which if not avoided may result in minor or moderate injury:

• Do not use the clipper with a damaged or broken blade as injury may result.

Explanation of symbols

Attention—Read accompanying documentation

Double insulated

Type B Applied Part

Do not reuse

Equipment Switch "On"

Equipment Switch "Off"

!

!

2

Product Safety Information

3M™ Surgical Clipper with Fixed Head 9671

SAVE THESE INSTRUCTIONS

Important Safety Instructions
When using this clipper, basic precautions should always be followed.
Read and understand all safety information before using.

INTENDED USE

• The 3M Surgical Clipper with Fixed Head system is comprised of a handle, a single-use blade assembly and a battery charger. It is intended to remove
body and head hair from patients in preparation for any medical procedure requiring hair removal.

• By replacing the common razor, this product will minimize the trauma associated with conventional shaving techniques.

• With proper use, the 3M Surgical Clipper with Fixed Head 9671 removes hair quickly and thoroughly; it has sufficient power to remove course hair, yet
is gentle enough for fine hair. It works well on all types of hair, either wet or dry and in delicate areas. For best performance, clip hair dry.

• The clipper has been designed and tested for use only with the 3M Surgical Clipper with Fixed Head model 9671 series battery chargers
(9672,9673,9674,9675, 9678) and the 3M disposable blade assembly 9670.

WARNING

To reduce the risks associated with fire and explosion, which if not avoided could result in death or serious injury and/or property damage:

• Do not operate clipper where aerosol (spray) products, flammable anesthetic mixture with air, nitrous oxide or oxygen administering equipment other
than nasal or mask types are being used.

• Emergency Medical Technicians (EMT’s) . . . do not use clipper on a patient whose clothing is saturated with flammable solutions such as gasoline, fuel
oil, solvents, etc.

• Avoid using around flammable alcohol or similar cleaning solution. If alcohol is used to clean the clipper, assure that the clipper and surrounding area
is ventilated of fumes before attaching the charger cord or switching on the clipper.

To reduce the risks associated with hazardous voltage, which if not avoided could result in death or serious injury:

• Do not attempt to plug or unplug the cord from an electrical outlet with wet hands.

• Unplug the clipper before cleaning.

• Do not place or store a clipper where it can fall or be pulled into a tub or sink. Do not immerse any part of the clipper in water or other solutions. Do
not retrieve a clipper while corded and in use that has fallen into or is submerged in water or other solutions. Unplug it from the wall outlet
immediately.

• Never charge or operate the clipper if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if it has been
dropped into water.

To reduce the risks associated with cross contamination, which if not avoided could result in death or serious injury:

• Do not reuse the blade assembly. Single use only.

• Always clean the clipper handle between patients.

!