3M 749 User Manual

3M™ Pedestal Stand 749

This pedestal stand can be used with 3M™ Wrist Strap Testers 740, 747 and 746. The

749 is made of stainless steel for durability and has a tip-over angle of greater than

45 degrees. Its unique top plate can support any of the 3M wrist strap testers, and it

can accommodate certain models of barcode and magnetic readers.

Designed for use in manufacturing areas, this unit is self-supporting, stand alone

and portable. The base plate is joined to the support column by stainless steel bolts

and has insulated washers to keep the operator from bypassing the grounding wire

and creating an electrical short. This feature helps guard against a false reading by

creating a second path for the circuit.

Speciﬁcations

Weight 9 lbs.

Assembled Height 40.5

Construction Stainless Steel

Includes: Stand pole, base, hardware, ground wire and instructions.

Assembly instructions on reverse side.

Assembly Instructions

Run grounding cable (ring terminal end) 1.

through top plate and through support

column. For 3M™ Wrist Strap Testers

740, use cable included in this kit. For

model 747, use the wire packaged with

that wrist strap tester.

Make sure that grounding cable is also 2.

placed through the isolation gasket.

Secure the ground cable ring terminal to 3.

the base plate using the bolts provided

(fasten to center hole).

Install the isolation sleeves inside the 4.

pre-drilled holes at the base of the

support column. Next, insert a

washer/head bolt into the sleeve

and hand tighten by turning the bolt

clockwise onto the threaded hole at

the base of the support column. Use a

Phillips Head screwdriver to tighten the

assembly.

Adhere the provided 3M5.

™

Dual Lock™

Reclosable Fasteners on both the top

plate and the 3M wrist strap tester.

Place tester over top plate and push

down to adhere both strips of Dual Lock

fasteners to each other. Make sure that

tester and top plate assembly make a

tight bond.

Important Notice

Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated with such use.

Warranty; Limited Remedy; Limited Liability.

This product will be free from defects in material and manufacture at the time of purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your

exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.

3M Electronic Solutions Division Static Control Products

926 JR Industrial Drive Sanford NC 27332 (866)722-3736 (866)722-3735 fax www.3M.com/static