AEG-Electrolux 21601C-M User Manual

Size:
478.48 Kb
Download

21601C/ 34611C/ 35601C/ 35610C 34602G/ 35600G/ 35601G/ 35604G

Gas hob

Table de cuisson

Kochmulde

Gaskookplaat

Piano di cottura

Operating and Installation Instructions

GB

Notice d’utilisation et d’encastrement

FR/BE

Gebrauchsund Einbauanweisung

DE/BE

Gebruiksaanwijzing en Installatievoorschrift

NL/BE

Istruzioni per l’uso e l’installazione

IT

ENGLISH

Important Safety Information

You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 350350

Installation

λThis hob must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.

λAny gas installation must be carried out by a registered CORGI installer.

λRemove all packaging before using the hob.

λEnsure that the gas and electrical supply complies with the type stated on the rating plate, located near the gas supply pipe.

λDo not attempt to modify the hob in any way.

Child Safety

λThis hob is designed to be operated by adults. Do not allow children to play near or with the hob.

λThe hob gets hot when it is in use. Children should be kept away until it has cooled.

λChildren can also injure themselves by pulling pans or pots off the hob.

During Use

λThis hob is intended for domestic cooking only. It is not designed for commercial or industrial purposes.

λWhen in use a gas cooking hob will produce heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose.

2

λWhen using the hob for a long period of time, the ventilation should be improved, by opening a window or increasing the extractor speed.

λDo not use this hob if it is in contact with water. Do not operate the hob with wet hands.

λEnsure the control knobs are in the ‘OFF’ position when not in use.

λWhen using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance.

λUnstable or misshapen pans should not be used on the hob as unstable pans can cause an accident by tipping or spillage.

λNever leave the hob unattended when cooking with oil and fats.

λNever use plastic or aluminium foil dishes on the hob.

λPerishable food, plastic items and areosols may be affected by heat and should not be stored above or below the hob unit.

Service

λThis hob should only be repaired or serviced by an authorised Service Engineer and only genuine approved spare parts should be used.

{Environmental Information

λAfter installation, please dispose of the packaging with due regard to safety and the environment.

λWhen disposing of an old appliance, make it unusable, by cutting off the cable.

Keep this instruction book for future reference and ensure it is passed on to any new owner.

These instructions are only valid for countries whose identification symbols are shown on the inside cover of this instruction booklet and on the appliance itself.

3

Contents

Instructions for the User

Important Safety Information

2

Guide to Use the instructions

4

Description of the Hob

5

Operation

6

Maintenance and Cleaning

7

Something Not Working?

8

Service and Spare Parts

9

Customer Care

9

Guarantee Conditions

10

Instructions for the Installer

Important safety requirements

12

Installation

13

Building In

15

Electrical connections

18

Wiring diagram

19

Fault Finding

20

Commissioning

23

Conversion from Natural Gas to LPG

24

Guide to Use the instructions

The following symbols will be found in the text to guide you throughout the Instructions: Safety Instructions

ΦStep by step instructions for an operation

Hints and Tips

{Environmental Information

This appliance is manufactured according to the following EEC directives: 73/23 EEC - 90/683 EEC - 93/68 EEC -

89/336 EEC - 90/396 EEC, current edition.

4

Description of the Hob

1

2

3

3

1. Hob Top

4

8 7 6 5

2.Rapid Burner

3.Semi-rapidBurners

4.Auxiliary Burner

5.Control knob for back right burner (semi-rapid)

6.Control knob for back left burner (semi-rapid)

7.Control knob for front left burner (rapid)

8.Control knob for front right burner (auxiliary)

INSTALLATION

Any gas installation must be carried out by a registered CORGI installer, and in accordance with existing rules and regulations.

The relevant instructions are to be found in the second section of this manual.

Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory.

5

Operation

Hob burners

ΦTo light a burner:

λ turn the relevant control knob anticlockwise to the maximum position, then push it down to ignite the burner. Upon, ignition, adjust the flame as required.

λ If the burner does not ignite, turn the control knob to zero, and try again.

When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).

Burner

minimum

maximum

 

diameter

diameter

Large (rapid)

180 mm.

260 mm.

Medium (semi-rapid)

120 mm.

220 mm.

Small (Auxiliary)

80 mm.

160 mm.

 

 

 

As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.

If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.

Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite

If the control knobs become difficult to turn, please contact your local AEG Service Force Centre.

FO 0204

A - Burner cap

B - Burner crown

C - Ignition candle

6

Maintenance and Cleaning

Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply.

The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.

The Hob Top

Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up liquid has been added.Avoid the use of the following:

-household detergent and bleaches;

-impregnated pads unsuitable for non-sticksaucepans;

-steel wool pads;

-bath/sink stain removers.

Should the hob top become heavily soiled, it is recommended that a cleaning product such as Hob Brite or Bar Keepers Friend is used.

Pan Supports

The pan supports are dishwasher proof. If washing them by hand, take care when drying them as the enamelling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner.

The Burners

The burner caps and crowns can be removed for cleaning.

Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove.

After cleaning, be sure to wipe dry with a soft cloth.

7

Something Not Working?

If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre.

SYMPTOM

SOLUTION

ν There is no spark when lighting the gas

υ Check that the unit is plugged in and the

 

electrical supply is switched on

 

υ Check that the RCCB has not tripped (if

 

fitted)

 

υ Check the mains fuse has not blown

 

υ Check the burner cap and crown have

 

been replaced correctly, e.g. after

 

cleaning.

ν The gas ring burns unevenly

υ Check the main jet is not blocked and the

 

burner crown is clear of food particles.

 

υ Check the burner cap and crown have

 

been replaced correctly, e.g. after

 

cleaning.

 

 

If after all these checks, your hob still does not operate correctly, contact your local Service Force Centre.

Please note that it will be necessary to provide proof of purchase for any in-guaranteeservice calls.

In-guaranteecustomers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

8

Service and Spare Parts

If you require spare parts or an engineer contact your local Service Force Centre by telephoning:

0870 5 929 929

Your call will be routed to the your local Service Force Centre.

When you contact the Service Force Centre, they will need the following information:

1.Your name, address and post code.

2.Your telephone number

3.Clear and concise details of the fault

4.The model and the serial number (see rating label on the back of this instruction booklet)

5.Date of purchase

Customer Care

For general enquiries concerning your AEG appliance and for further information on AEG products, contact our Customer Care Department by letter or telephone as follows:

Customer Care Department

AEG Domestic Appliances

55-77High Street

Slough

Berkshire

SL1 1DZ

Tel : 08705 350 350

9

Guarantee Conditions

AEG offer the following guarantee to the first purchaser of this appliance.

1.The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.

The guarantee does not cover commercial use.

2.The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials. The guarantee does not cover appliances where defects or poor performance are due to misuse, accidental damage, neglect, faulty installation, unauthorised modification or attempted repair, commercial use or failure to observe requirements and recommendations set out in the instruction book.

This guarantee does not cover such parts as light bulbs, removable glassware or plastic.

3.Should guarantee repairs be necessary the purchaser must inform the nearestAEG Service Force Centre (manufacturer’s service or authorised agent). AEG reserves the right to stipulate the place of the repair (i.e. the customer’s home, place of installation or AEG workshop).

4.The guarantee or free replacement includes both labour and material.

5.Repairs carried out under guarantee do not extend the guarantee period for the appliance. Parts removed during guarantee repairs become property of AEG.

6.The purchaser’s statutory rights are not affected by this guarantee.

European Guarantee

If you should move to another country within Europe then your guarantee moves with you to your new home subject to the following qualifications:

*The guarantee starts from the date you first purchased your product.

*The guarantee is for the same period and to the same extent for labour and parts as exist in the new country of use for this brand or range of products.

*This guarantee relates to you and cannot be transferred to another user.

*Your new home is within the European Community (EC) or European Free Trade Area.

*The product is installed and used in accordance with our instructions and is only used domestically, i.e. a normal household

*The electrical supply complies with the specification given in the rating label.

*The product is installed taking into account regulations in your new country.

Before you move, please contact your nearest Customer Care centre, listed below, to give them details of your new home. They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances.

France

Senlis

+33 (0) 3 44 62 29 29

Germany

Nürnberg

+49 (0) 800 234 7378

Italy

Pordenone

+39 (0) 800117511

Sweden

Stockholm

+46 (0) 8 672 53 60

U K

Slough

+ 44 (0) 1753 219899

10