ZyXEL Prestige 610 Quick Start Manual

Prestige 610

ADSL PCI Modem

Quick Start Guide

Version 2.10

May 2003

System Requirements

Before installation, make sure you have the following requirements.

 Pentium II 233 or above
 At least 32 MB RAM (64 MB recommended)
 A minimum of 10 MB available hard disk space or more
 An available PCI slot
 CD-ROM drive
 Windows 98/98 SE/Me/2000/XP
 Windows 98/98 SE users may need the Windows 98/98 SE CD
 An ADSL Internet service account

Internet Account Information

Fill in the table below with information from your Internet Service Provider (ISP)
or telephone company before installation. You may not need to fill in every blank.

Virtual Path Identifier (VPI):

Virtual Circuit Identifier (VCI):

Modulation  T1.413

 Multimode
 G.lite
 G.DMT

Connection Type (driver type)

 LAN

 RFC 1483 IPoATM  VC

 LLC

 RCF 1577 Classical IPoATM

IP address: __________ Subnet Mask : ___________
Gateway : __________ DNS (if given): ___________

 Bridged
 Routed

 WAN

 RFC 2364 PPPoATM  LLC

 NULL

 RFC 2516 PPPoE

Username: __________ Password: __________

The WAN driver uses Dial-up Networking to establish the

ADSL connection. The LAN driver establishes an always-on

ADSL connection automatically.

2

Hardware Installation

Follow the steps below to install the Prestige in your computer.

Save and close all programs before you begin.

1. Turn off the computer and peripheral

device, such as the printer. Then
disconnect the computer power cord from
the power source.

2. Ground yourself by wearing an anti-static

wrist strap or touching a metal object.

3. Remove the computer cover and the

Prestige from its packaging.

4. Insert the Prestige into an available PCI

slot. Make sure the Prestige’s contacts are
fully seated in the PCI slot.

5. Secure the Prestige to the computer with a

bracket screw.

6. Replace the computer cover and plug in

the power cord.

PCI Slot

Hardware Connection

Connect the Prestige directly to the telephone wall jack with a telephone cable as
shown in the figure below.

Driver Installation

Follow the steps to install the device driver for the Prestige to work properly.

1. When a Found New Hardware Wizard window displays. Click Cancel to

close the wizard window.

2. Insert the supplied CD-ROM into the CD-ROM drive in your computer.

The CD-Rom auto runs and an AutoPlay Menu window displays as shown.
(If no screen displays, find and double-click Open.exe on the support
CD-ROM.)

3