Zyxel P-2612HW specifications
P-2612HW-F1
802.11g Wireless ADSL VoIP IAD
Firmware v3.70
Edition 1, 12/2008
DEFAULT LOGIN DETAILS
IP Address: http://192.168.1.1
Username: admin
Password: 1234
www.zyxel.com
Copyright 2008
ZyXEL Communications Corporation
Device Panels
WLAN
BUTTON
DSL
PORT
POWER
LED
ETHERNET
PORTS
ETHERNET
LED
WAN
PORT
WLAN
LED
DSL/WAN
ADSL
LED
INTERNET
LED
PHONE
PORTS
WAN
LED
RESET
PHONE 1, 2
LEDS
ON/OFF
POWER
2
ENGLISH
Overview
The P-2612HW-F1 is a router which combines high-speed ADSL
Internet access, a built-in switch, a firewall and high-speed wireless
networking capability. It also has a phone port for making calls over the
Internet (Voice over IP or VoIP).
Requirements
Make sure you have the following things before you start.
• Internet access - account information provided by your ISP, such as
user name, password, and so on.
• Internet Explorer 6.0 or later or Netsca pe Navigator 7.0 or later, with
JavaScript enabled.
See the User’s Guide for all configuration details including file sharing
and setting up a shared printer.
3
To read the User’s Guide insert the CD that came in the box into your
CD-ROM drive. A screen should pop up. Navigate to the User’s Guide
from this screen. If a screen does not pop up, open Windows Explorer
(click My Computer), click on the CD-ROM drive (usually drive D) and
navigate to it from there.
4
Hardware Connections
ENGLISH
Remove the plastic cover from the P-2612HW-F1 before you
use it.
1. DSL: Use a telephone wire to connect this port to a telephone jack (or
the DSL or MODEM jack on a splitter, if you have one).
WAN: If you have a DSL router or modem already in your network or
you want to use a cable modem, push the DSL/WAN switch to the
WAN side and use an Ethernet cable to connect this port to an
Ethernet jack with Internet access.
2. ETHERNET: Use an Ethernet cable to connect a computer to one of
these ports for initial configuration and/or Internet access.
5
3. PHONE: Use a telephone cable (and any telephone adaptor provided
with your P-2612HW-F1) to connect a telephone to the PHONE 1 or
PHONE 2 port.
4. Use the power adaptor provided with your P-2612HW-F1 to connect
an appropriate power source to this socket.
5. Push the power button to the on position.
Look at the LEDs (lights) on the top panel of the P-2612HW-F1.
• The POWER light blinks during start-up and is green once the P-
2612HW-F1 is ready.
• Each ETHERNET light turns on if the corresponding ETHERNET
port is properly connected. The lights blink when the P-2612HW-F1
is sending or receiving data through the corresponding ETHERNET
port.
• The ADSL light stays on if a physical DSL connection exists and
blinks when transmitting data.
The WAN light stays on if this port is properly connected and blinks
when transmitting data.
The INTERNET light is green when Internet access is available.
• The PHONE lights stay on when your SIP account is registered and
they blink if the receiver is off the hook.
6
Loading...