ZTE AC2726 User Manual

CDMA2000 1X EV-DO Wireless Data Terminal User Guide
CDMA2000 1X EV-DO Wireless Data Terminal
User Guide
ZTE Corporation http://www.zte.com.cn
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
Copyright Statement
Copyri ght © 2009 by ZTE Corporation
All rights reserved.
No part of this publication may be excerpted, reproduced, translated or utilized in any form or by
any means, electronic or mechanical, including photocopying and microfilm, without the prior
written permission of ZTE Corporation.
ZTE Corporation reserves the right to make modifications on print errors or update specifications
in this manual without prior notice.
ZTE Corporation http://www.zte.com.cn
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
Table of Contents
1. Introduction................................................................................................................................... 1
2. Precautions .................................................................................................................................... 1
3. Appearance.................................................................................................................................... 2
3.1 Introduction ............................................................................................................................... 2
3.2 Insert R-UIM Card.................................................................................................................... 2
3.3 Operation Guide of Data Cable ...............................................................................................3
4. Install and Uninstall...................................................................................................................... 3
4.1 System Requirements ............................................................................................................... 3
4.2 Installation Guide..................................................................................................................... 3
4.2.1 Install .............................................................................................................................. 3
4.2.2 Uninstall ......................................................................................................................... 4
5. Run the Application ...................................................................................................................... 4
6. Connect/Disconnect ...................................................................................................................... 5
7. Connection Records...................................................................................................................... 5
8. Voice Call ......................................................................................................................................... 6
9. Call History ...................................................................................................................................... 7
10. Short Message................................................................................................................................ 8
11. Phone Book .................................................................................................................................... 9
12. Setting........................................................................................................................................... 10
13. Help............................................................................................................................................... 12
14. Trouble-shooting.......................................................................................................................... 12
15. FCC Regulations.......................................................................................................................... 13
16. RF Exposure Information (SAR)................................................................................................14
ZTE Corporation http://www.zte.com.cn
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
1. Introduction
Thank you for choosing ZTE Corporation’s CDMA2000 Wireless Data Terminal (hereinafter referred to as Data Terminal).
Data Terminal supports both CDMA2000 1X EV-DO and CDMA2000 1X network. In the area where there is signal, it allows you to go surfing on the Internet, send & receive short messages, and make & receive phone calls.
The pictures in this help are only used to demonstrate your Data Terminal’s functions, so they are maybe different from what you see on your Data Terminal. Please refer to your Data Terminal if they are differences.
2. Precautions
z Use the original accessories or those authenticated by the manufacturer. Using any
unauthenticated accessories may affect the data terminal’s performance, violate the warranty
provisions or relevant national regulations about telecom terminals, or even cause body
injury.
z Do not disassemble, modify, frequently pull/plug the antenna, stretch, rotate or bend the
antenna with great force.
z Before pulling out the data terminal, please use Windows safely removing the hardware and
make sure to exit the application. Do not directly pull out the terminal to avoid the damage of
data terminal or the influence on the normal operation of operating system.
z Do not forcefully plug/pull the data terminal to avoid the damage of connector. z Do not use your data terminal near weak signal or high-precision electronic devices. Radio
wave interference ma y cause misoperation of electronic devices or other problems.
z Turn off your data terminal on airplane where it’s forbidden to use it. The data terminal may
affect the normal operation of electronic devices, therefore please follow the relevant
regulations when using your mobile phone on airplane.
z Turn off your data terminal in hospital where it’s forbidden to use it. The data terminal may
affect the normal operation of medical apparatus, therefore please follow the relevant
regulations when using your mobile phone in hospital.
z Please do not use the data ter minal near flammable or explosive materials; otherwise it might
cause failure or fire.
z Keep your data terminal away from water. This may cause overheating or failure if water or
any other kind of liquid enters your mobile phone. Please do not use your data terminal near
high temperature, damp or dusty place.
z Keep your data terminal away from chil dren to avoid shock, plunge or impact. It may cause
body injury when the data terminal is used as a toy.
ZTE Corporation 1 http://www.zte.com.cn
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
w
w
3. Appearance
3.1 Introduction
Side Vie
Antenna
Jack
Rear Vie
Cap
USB Interface
Back Cover
3.2 Insert R-UIM Card
Note: If your data terminal doesn’t need R-UIM card, please skip this section.
1. Pull out the tap
2. Take out the R-UIM card cover in the direction indicated by the arrow
3. Insert R-UIM card as below figure
4. Push back R-UIM card cover.
ZTE Corporation 2 http://www.zte.com.cn
CDMA2000 1X EV-DO Wireless Data Terminal User Guide
3.3 Operation Guide of Data Cable
Generally, the Data Terminal could be directly connected with USB port. You could also connect
the Data Terminal with PC by using the accompanying data cable, as shown in the following figure. Connect Interface with Data Terminal, and interface with PC's USB port. If the power supply from USB port is insufficient, connect both interfa ce and wit h USB port
together.
4. Install and Uninstall
4.1 System Requirements
The Data Terminal supports the following operating system:
¾ Windows 2000
¾ Windows XP
¾ Windows Vista
PC minimum configurations:
CPU Pentium-II/233MHz
USB interface 2.0 (USB1.0 and 1.1 compatible)
Optical Drive CD-ROM (for installation only)
Memory 64 MB
Disk Space 50 MB (used for installation of application)
4.2 Installation Guide
Take Windows XP for example. Under other operating systems, please refer to the installation
under Windows XP. Do not insert the Data Terminal before installation.
4.2.1 Install
1. Please connect Data Terminal to PC through USB interface. You could use t he data cable to
connect.
2. The installation driver will automatically run. Please install according to the installation wizard.
3. The system will automatically find new hardware and install the driver. Wait for a while. Click
"Finish" after the installation is completed.
ZTE Corporation 3 http://www.zte.com.cn
Loading...
+ 11 hidden pages