Zinwell PWQ-5101C Quick Installation Manual

QUICK INSTALLATION GUIDE

Powerline
Wireless Network

WPS Button

Group Button

LAN Port

Power Button

ON: Ethernet link detected

Reset Button

LEDs LIGHT INDICATOR DEFINITION

Group Button

Reset Button

LAN Port

Press 1~3 secs to

reset to factory default

Power LED

Ethernet Link/

Act LED

PLC LED

Power LED

PLC LED

WLAN Link/Act LED

Ethernet Link/Act LED

ON: Linked w/ other PLC device

Green: Wi-Fi is encrypted
Red: Wi-Fi is not encrypted

Press to join an
encrypted Wi-Fi network.

Clone AP Button

Press to duplicate current Wi-Fi network.

Press 1~3 secs to join an
encrypted PLC network.

Press over 10 secs to create
the encrypted PLC network.

Press 1~2 secs to
reset to factory default

BEFORE GETTING STARTED

Do Not plug PLC adapter into “surge protector”.
PLC data transmission might be blocked.

Modem / Router

Make sure that router is connected to the Internet.

Internet

500 Mbps
Powerline Bridge

500 Mbps Powerline
Wireless N Extender

/Default

To switch between WPS and Clone AP,
please login to Advanced Wi-Fi Setting
via web browser.

For Instruction Manual go to

http://www.zinwell.com.tw/manual/PWQ-5101C_UM.zip

IB04722799-0

**Make sure router is WPS supported.

Plug the PLC adapter to AC outlet and connect to router
or broadband modem with an Ethernet cable (provided)

Plug the PLC Wi-Fi Extender to AC outlet and place it in
a location you wish to extend Wi-Fi access.

CREATE AN ENCRYPTED PLC NETWORK GROUP

ESTABLISH POWERLINE NETWORK

DUPLICATE CURRENT SSID & PASSWORD

WITH ONE BUTTON

Step 1

Step 2

Search Wi-Fi network and connect it with (WPA-PSK)
default password.*

* The default Wi-Fi password appears on the product label.

Step 3

User can easily create an encrypted PLC network with
128-bit encryption for network security and data
protection. Simply press GROUP

button on adapters to
set up hassle-free PLC encrypted network. To do so,
please follow below steps!

Modem / Router

PC

Modem / Router

Press GROUP button on both adapters over 10 secs
until LED light turns off and on at once to generate new
encrypted PLC network. (PLC LED light will be off)

Step 1

Step 1

GROUP

button

GROUP

button

A

B

Press GROUP button of adapter A again for 1~3 sec to
start pairing procedure. (Power LED will start blinking)

Step 2

Step 2

Press GROUP button of adapter B for 1~3 sec to start
pairing procedure. (Power LED will start blinking)

Once Pairing procedure is completed, both of PLC LED
light will be on.

Step 3

TROUBLESHOOTING

Make sure PLC LED is on.

What if Powerline adapters are not connected?

a. Verify that PLC LED adapters are

plugged into a power outlet directly.

b. Press RESET button for 2 seconds to

recover the default settings.

c. Shorten the distance between PLC

adapters.

If not,

Clone AP

Simply press Clone AP button to duplicate your
current Wi-Fi SSID and password.

Press Clone AP

button* on the extender

and Wi-Fi LED will start blinking.

Press WPS

button on the router** and Powerline
Wi-Fi extender will duplicate current Wi-Fi SSID
and password from the router. The extender will
reboot once procedure is completed.

Smartphone

Tablet

SSID: OOO
Password: XXX

SSID: OOO
Password: XXX

button

(Default funtion:WPS)

*Make sure WPS button has been switched

to Clone AP button via web browser.
Please refer to p.13 on manual.