Zeon IN6102 CALIBRE 520 Operation Manual

Calibre 520

Automatic Movement Operation Manual

Automatic watches can be used only by those who are reasonably active as the automatic winding relies on a regular movement of the wrist. The watch must be given an initial manual wind of 8 to 10 turns and provided that it is worn on the wrist for a minimum of 8 hours each day it will continue to function indefinitely and may be taken off the wrist for a maximum period of 30 hours. If this period is exceeded the movement will stop and another manual wind will be necessary. It must be remembered that when worn in bed the movement of the wrist is insufficient to operate the automatic winding.

Time Stand Accuracy

1) 21,600 beats per hours

2) Accuracy between -30 to +30 seconds per day worn under normal conditions.

Butterfly Strap Adjusting Instruction

Firstly, open the butterfly buckle and then pull out the pin. Adjust the strap to the required length, and then push back the pin into the correct hole. Finally, close the butterfly buckle until it clicks into place.

Page 1

Instructions for Time Setting

1) Pull the crown out to Second position and turn the crown clockwise until the day of the week is corrected. The day and date will now be corrected, now set the time but make sure the time is set onto AM or PM. Finally push the crown back to Normal position.

2) The 24 Hour dial will indicate AM or PM

Instruction for Manual Year Setting

Press button B to set the year manually.

Page 4

Water Resistance Table

Level of Water Resistance

None Yes No No No No No

3 ATM (30m/ 100ft 5 ATM (50m/ 150ft) 10 ATM (100m/ 300 ft)

Water resistance is not permanent. In the course of time, the gaskets of the case and crown may become worn and reduce the water resistance of your watch. We recommend the periodic checking

Normal Crown – always make sure it is pushed fully into case Screw down Crown – tighten screw down crown completely to screw lock position.

To maintain water –resistance crystal, crown and case must remain intact

Exposure to Salt Water

If your watch is designed for sports or working in the water and it becomes exposed to salt water or significant amounts of perspiration, it should be rinsed in fresh water and dried thoroughly with a soft dry cloth.

Important

Buttons must not be operated while in contact with water

Suitable for Everyday use

Yes Yes No No No No

Yes Yes Yes Yes No No

Yes Yes Yes Yes Yes No

Can withstand accidental splashing

Suitable for Swimming

Page 2

Suitable for Pool Size

Suitable for snorkelling or water sports

Suitable for high board diving or subaqua diving

Calibre 520

IN1601, IN2800, IN2801, IN3900, IN3202, IN6102

Page 5

Functions

- Hours

- Minutes

- Seconds

- Day of the week dial

- Date of the Month and Month

- 24 hours dial

- Manual Year dial

- Water Resistance – Check the back of the watch and refer to the Table.

Important

 Do not set the day & date between 06.00 PM and 06.00 AM, as this may

Instructions for Day, Date and Month Setting

cause damage to the movement.

1) To achieve an accurate day of the week setting, pull crown out to first position and turn the crown anti-clockwise until a day prior to the day you require is achieved i.e. if today is Wednesday then set it onto Tuesday.

2) Now turn the crown clockwise until a date prior to the date you required is achieved. i.e. today is the 16th then set it onto the 15th.

3) Push the crown back to normal position.

4) Press button A to set the correct Month

Page 3