Zenoah G270RC, G240RC User Manual

OWNER'S MANUAL

Thank you for using ZENOAH ENGINE.

● Please read this Owner’s Manual thoroughly before operating and use the
engine correctly according to this Owner’s Manual.
(For safety reasons, please contact your sales dealer before operating this
engine if there is something that you do not understand.)

● This engine has been designed for the use of radio control car.
Please use this engine in conjunction with the manual for radio control car or
radio control equipment you are going to use.

● Any modification of the engine or any use of other applications is prohibited.

● The purchaser (user) shall bear all obligations and responsibilities stipulated

by law, local ordinance and the likes.
Husqvarna Zenoah Co., Ltd. shall bear no responsibility whatsoever.

Model: G240RC/G270RC
Model code: X374323111 (G240RC)
Model code: X374326111 (G270RC)

848ER893A0 (804)

SPECIFICATIONS.....................................................4

SAFETY PRECAUTIONS..........................................5

FUEL .........................................................................7

ENGINE STARTING..................................................8

OPERATION .............................................................9

MAINTENANCE ......................................................10

SPECIAL TOOLS ....................................................15

SERVICE GUIDE ....................................................16

TROUBLE SHOOTING ...........................................19

PARTS LIST (G240RC)...........................................22

PARTS LIST (G270RC)...........................................26

WARRANTY............................................................30

CONTENTS

SPECIFICATIONS

Engine Type G240RC G270RC

Overall Size (L x W x H) 166 x 205 x 196mm

Weight 2.07kg

Displacement 22.5cm

3

25.4cm

3

Clutch Engagement 6000rpm (STD Spring)

Carburetor Type WT-813A

Spark Plug NGK CMR7H

Spark Plug Gap 0.65mm

Rotating Direction Counter-Clockwise (View From PTO)

SAFETY PRECAUTIONS

● These safety precautions are to prevent you and those people in the
vicinity from incurring harm or damage. Make sure to observe these
precautions and constantly strive to ensure safety.

● Safe use of the engine is your personal obligation and responsibility.
Constantly take care to act with good judgment as you enjoy your
hobbies.

• The fuel is toxic. Do not let it get into your eyes or mouth. Store it in a
cool place, out of the reach of infants and children.

• Use of open flames around the fuel is strictly prohibited, because of
danger of fire.

• To prevent burns, make sure not to touch the engine while it is
operating or immediately after it has stopped.

• Do not run the motor in poorly ventilated places. Do not breathe the
exhaust, as it is a health hazard.

•Please wear clothing that facilitates your safety. Remove all scarves,

SAFETY PRECAUTIONS

overly long sleeves, neckties and the like. Failure to do so could result
in injury.

• When mounting the engine to a model, make sure to follow the model’s
operating manual. If necessary, reinforce the engine mounting unit and
the peripheral parts.

FUEL

• Mix gasoline (octane over 95) and high grade 2 cycle engine oil (mixing use type;
F3C grade or ISO EGC grade) at mixing ratio 25~40:1.

• The mixing ratio is according to the oil recommendation.

[ NOTE ]

1) Never use any alcohol fuel or alcohol added fuel, or the rubber parts in the
carburetor and engine will be damaged.

2) Gasoline is very flammable. Avoid smoking and any fires near fuel.

3) To prevent all possible problems on fueling system, make sure to use the fuel filter
which has more than 300 mesh or equivalent and gasoline proof rubber pipe or
equivalent.
Incorrect fuel filter may cause engine trouble like fuel passage stuffing in carburetor,
or piston surface scratching etc.

ENGINE STARTING

• Push the primer pump several times until overflown fuel
flows out. (Fig.1)

• Close the choke lever, and move the throttle lever
1/4~1/3 open position. (Fig.1)(Fig.2)

• Pull the starter(knob) quickly until first firing noise.
(Fig.3)

• Open the choke(Fig.2), throttle idle~1/4 open

• Pull the starter quickly

• Operate engine for a few minutes for the warming up.

• In case of engine warm condition, choking may not be
necessary.

• Over choking may cause starting difficulty due to wet
spark plug.
In this case change spark plug or dry it, and remove
fuel rest in the cylinder by pulling starter.

IMPORTANT

Fig.1

Throttle Lever

Fig.2

Fig.3

Primer Pump

Choke Lever

Close

Open

OPERATION

• This engine is already tuned up to get high power and high speed, and needs correct
maintenance to keep such high performance.

• The details for operation may be described in the separate owners manual to be
issued by car manufacturer.

• Be sure to have the engine cool down for 30 seconds at idle speed after full throttle
running.

MAINTENANCE

1) MAINTENANCE CHART

Before Every Every

Items Action Use 25 hours 100 hours Note

Leakage,

Check ✔

Damage/Crack

Idling Speed Check/Adjust ✔✔✔

Air-cleaner Check/Cleaning ✔✔ Replace if necessary

Spark Plug(gap) Check/Adjust ✔✔ ↑

Cylinder(barrel) Check/Cleaning ✔✔ ↑

Piston, Ring Check/Cleaning ✔✔ ↑

Muffler & Bolt Check/Cleaning ✔✔✔ ↑

Bearings Check/Cleaning ✔✔ ↑

Crank Shaft Check/Alignment ✔ ↑