Zebra Technologies MD-ZLAN11B Users manual

Rhein Tech Laboratories, Inc. Client: Zebra Technologies
360 Herndon Parkway FCC: Part 15.247
Suite 1400 IC: RSS-210

http://www.rheintech.com

Model: ZLAN11B

FCC ID: I28MD-ZLAN11B Herndon, VA 20170

Appendix D: User Manual

Please refer to the following page, taken from the user manual.

Page 22 of 29

Zebra 802.11b WLAN Radio Module

The following section only applies when the Zebra 802.11b WLAN radio module (with
FCC ID: I28MD-ZLAN11B) is installed in a RW printer. The FCC ID number is on the serial number
label on the back of the printer and can be read with the module installed. Other than conditions specified
elsewhere in this manual, only one of the radio options can be installed in the printer at one time and the
antenna used for these transmitters must not be co-located or must not operate in conjunction with any
other antenna.

Caution • The radiated output power of this internal 802.11b radio is far
below the FCC radio frequency exposure limits. Nevertheless, this radio
must be used in such a manner that the antenna is 2.5 cm. or further
from the human body. The radio and antenna are mounted internally
in this printer such that when the printer is worn with the back of the
printer against the body and the front of the printer (where paper exits)
away from the body, then the 2.5 cm distance between the antenna and
the users body will be met. Do not use the printer in an unauthorized
manner.