Zebra MC9500-K Mobile Computer CRD9500-F800ER 8-bay Ethernet/Charge Cradle Installation Guide English

CRD9500-F800ER
8-bay Ethernet/Charge Cradle

Installation Guide

WALL MOUNTING

CAUTION

Use mounting hardware (screws and/or

anchors) appropriate for the type of wall you

are mounting the bracket onto. The 8-bay

Cradle mounting slots dimensions are 5 mm

(0.2 in.). Fasteners must be able to hold a

minimum of 18.1 Kg (40 lbs.)

For proper installation consult a professional

360.36 mm

13.4 in.

270.50 mm

10.65 in.

Zebra reserves the right to make changes to any product to
improve reliability, function, or design. Zebra does not assume any
product liability arising out of, or in connection with, the application
or use of any product, circuit, or application described herein. No
license is granted, either expressly or by implication, estoppel, or
otherwise under any patent right or patent, covering or relating to
any comb
or process in which Zebra products might be used. An implied
license exists only for equipment, circuits, and subsystems
contained in Zebra products.

ination, system, apparatus, machine, material, method,

installer. Failure to install the 8-bay Cradle

properly can possibly result in damage to the

hardware.

1. Install four screws into the wall using

the dimensions indicated on the right.

The screw heads should protrude

2.5 mm (3/32”) from the wall.

3. Connect an Ethernet cable to Port 1 on

the top cradle.

4. Align the 8-bay cradle’s four mounting

Mounting Hole

Zebra Technologies Corporation
Lincolnshire, IL U.S.A.
http://www.zebra.com

Zebra and the Zebra head graphic are registered trademarks of ZIH
Corp. The Symbol logo is a registered trademark of Symbol
Technologies, Inc., a Zebra Technologies company.
© 2015 Symbol Technologies, Inc.

72-144328-02 Revision A — February 2015

holes with the four screws on the wall.

5. Place the 8-bay cradle on the screws

and ensure that the cradle is secure.

6. Plug the Power cable into an AC

outline.

SHELF MOUNTING

1. Attach the shelf bracket to the bottom

of the 8-bay cradle using four M4x0.7

8 mm screws.

2. Place the 8-bay cradle on the shelf

with end of the shelf bracket hanging

over the shelf lip.

3. Slide the J-bracket onto the shelf lip

and shelf bracket and secure using

two M4x0.7 8 mm screws.

4. Feed the belt through the bracket slot

and the J-bracket slot.

5. Feed the belt through the buckle.

Shelf Bracket

J-Bracket

Shelf Bracket

Strap

6. Slide the J-backet onto the shelf lip.

7. Tighten the belt.

8. Connect an Ethernet cable to Port 1 on

the top cradle.

9. Plug the Power cable into an AC

outline.

Strap Buckle

Shelf Bracket

J-bracket

J-bracket