MC93XX Un-Powered Forklift Mount
Installation Guide
1.
Secure RAM Clamp Base to
forklift mounting surface using
two screws and nuts.
2.
Attach RAM Socket Arm to RAM
Clamp Base and Forklift Mount
Holder.
3.
Turn the Socket Arm hand-screw
clockwise until tight.
4.
Insert device in Forklift Mount
Holder at a 45° angle in one of
two ways (shown below).
5.
Rotate and snap device into
place.
6.
If required, secure device with
rubber strap and snap into place.
Strap
Forklift Mount Holder
2
1
1
3
RAM Socket Arm
RAM Clamp Base
RAM Clamp Base
Forklift Mounting Surface
5
4
5
6
4
Note: Use strap in this orientation for added retention of the device.
ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corporation,
registered in many jurisdictions worldwide. All other trademarks are the property of their
respective owners. ©2019 Zebra Technologies Corporation and/or its affiliates. All rights
reserved.
MN-003553-01 Rev. A - July 2019
Loading...