72-96281-02 Revision A — February 2016
Introduction
MOUNTING PLATE
SWIVEL JOINT
SWIVEL PLATE
EXTENSION ARM
MOUNTING PLATE
SWIVEL JOINT
SWIVEL BASE
EXTENSION ARM
MOUNTING PLATE
SWIVEL PLATE
SWIVEL JOINT
SWIVEL BASE
There are three antenna mounting kit configurations, Standard,
Heavy Duty and Industrial. The Heavy Duty and Industrial kits offer a
choice of either a 16 or a 24 inch extension arm.
Standard Antenna Mounting Kit (BRKT-70661-01R)
Heavy Duty Antenna Mounting Kit
(BRKT-70662-01R and BRKT-70663-01R)
Antenna Mounting Brackets
Quick Reference Guide
Industrial Antenna Mounting Kit
(BRKT-70664-01R and BRKT-70665-01R)
Mounting
The antenna mounting kits have four 1/4 inch holes to facilitate
mounting. Use standard 1/4 inch hardware that is appropriate for the
mounting surface. Mount the brackets to provide the best possible
signal access. Exercise care not to drill mounting holes that may
cause unintended equipment damage. To mount the antenna
mounting kit:
1. Use the mounting template (back of this QRG) to mark the
approprate hole pattern.
2. Prepare the mounting surface using pilot holes, mollys, etc. that
are approprate for the mounting surface. This hardware is not
provided in the mounitng kit.
3. Attach the Swivel Joint (for the Standard kit) or the Extension Arm
(for the Heavy duty or Industrial kits) to the mounting surface.
4. Attach the remaining swivel bases, swivel plates, swivel joints
and the mounting plate as shown for each of the mounting kits.
© 2016 Zebra Technologies, Inc. All rights reserved.
Zebra reserves the right to make changes to any product to improve reliability, function,
or design.
Zebra does not assume any product liability arising out of, or in connection with, the
application or use of any product, circuit, or application described herein.
No license is granted, either expressly or by implication, estoppel, or otherwise under
any patent right or patent, covering or relating to any combination, system, apparatus,
machine, material, method, or process in which Zebra products might be used. An
implied license exists only for equipment, circuits, and subsystems contained in Zebra
products.
Warranty
For the complete Zebra hardware product warranty statement, go to:
http://www.zebracom/warranty.
Zebra Technologies Corporation
3 Overlook Point
Lincolnshire, IL 60069, U.S.A.
http://www.zebra.com
Zebra and the stylized Zebra head are trademarks of ZIH Corp., registered in
many jurisdictions worldwide. A ll other trademarks are the property of their
respective owners.
©2016 Symbol Technologies LLC, a su bs id iary of Zebra Technologies
Corporation. All rights reserve d.
.ni
0.5.n
i
5.2.ni 5.1.ni 0
.
0
"88.5 X "57.2
snoisnemiD
snoisnemiD
"05.2 X "05.1
snoisnemiD
"52.3 X "52.3
Standard Mounting Template
Industrial Mounting Template
Heavy Duty Mounting Template
BRKT-70661-01R
BRKT-70662-01R / BRKT-70663-01R
BRKT-70664-01R / BRKT-70665-01R
Loading...