Zanussi ZEC 40 User Manual

FREEZER

CONGELADOR

ZEC 40

2222 258-06

INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES

CONTENTS

Warnings ................................page 3

Conservation ...............................page 4

Installation ................................page 5

Positioning ...............................page 5

Before using ...............................page 5

The electrical connections ..........................page 6

Location ................................page 7

Door reversibility .............................page 7

Fitting a decorative door panel ........................page 8

Your appliance ...............................page 10

Operation ................................page 11

The controls ...............................page 11

Frozen food storage ............................page 11

Ice making ...............................page 12

Thawing ................................page 12

Freezing fresh food ............................page 12

Helpful hints when buying food ........................page 12

Defrosting ...............................page 13

Starting ................................page 13

Normal sound ..............................page 13

Health and safety guidelines ..........................page 14

Maintenance and cleaning ...........................page 15

Internal cleaning .............................page 15

When the appliance is not in use ........................page 15

What happens if something goes wrong? ......................page 16

Guarantee conditions .............................page 17

TECHNICAL SPECIFICATIONS

POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY*

GROSS CAPACITY NET CAPACITY STAR RATING

* This ﬁgure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located.

220-240 V / 50 Hz 120 W

1.30 kWh 120 l

101 l

“

WARNINGS

IT IS MOST IMPORTANT THAT THIS INSTRUCTION BOOK SHOULD BE RETAINED WITH THE APPLIANCE FOR FUTURE REFERENCE. SHOULD THE APPLIANCE BE SOLD OR TRANSFERRED TO ANOTHER OWNER, OR SHOULD YOU MOVE HOUSE AND LEAVE THE APPLIANCE, ALWAYS ENSURE THAT THE BOOK IS SUPPLIED WITH THE APPLIANCE IN ORDER THAT THE NEW OWNER CAN GET TO KNOW THE FUNCTIONING OF THE APPLIANCE AND THE RELEVANT WARNINGS.

THESE WARNINGS ARE PROVIDED IN THE INTEREST OF SAFETY. YOU MUST READ THEM CAREFULLY BEFORE INSTALLING OR USING THE APPLIANCE.

This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product.

Any electrical work required to install this appliance should be carried out by a qualiﬁed electrician or competent person.

This product should be serviced by an authorised ZANUSSI Service Force Centre, and only genuine spare parts should be used.

It is dangerous to alter the speciﬁcations or modify this product in any way.

Care must be taken to ensure that the appliance does not stand on the electrical supply cable.

ZANUSSI domestic refrigerators, freezers and fridge/freezers are designed to be used speciﬁcally for the storage of edible foodstuffs only.

The cooling plate or refrigerated freezer shelves in this appliance contain channels through which the refrigerant passes. If these are punctured this would cause substantial damage to the appliance and result in food loss. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Under NO circumstances should solid ice be forced off the lining or shelves. Solid ice should be allowed to thaw, when defrosting the appliance. See Defrost instructions.

The appliance should be left for 2 hours after installation before it is turned on in order to allow the refrigerant to settle.

This appliance is heavy. Care should be taken when moving it.

Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or “frost/freezer burns”.

Ice lollies can cause “frost/freezer burns” if consumed straight from the freezer.

Manufacturers’ storage recommendations should be strictly adhered to. Refer to relevant instructions.

Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Refer to your local ZANUSSI Service Force Centre and always insist on genuine spare parts.

There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in possible food loss. See installation instructions.

Parts which heat up should not be exposed. Wherever possible, the back of the appliance should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions.

Before defrosting, cleaning or maintenance work is carried out, be sure to switch off the appliance and unplug it.

Frozen food must NOT be re-frozen once it has thawed out.

Do not place carbonated or ﬁzzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance.

08/96

2222 258-06

CONSERVATION

In the interests of the Environment:

When disposing of your old fridge, freezer or fridge/freezer.

Help to keep your country tidy – use authorised disposal sites for your old appliances.

For maximum efficiency:

Make sure that the appliance is cleaned properly. Make sure that the door is closed properly. Do not position the appliance near to sources of

heat. Do not over-ﬁll your appliance, air MUST be

allowed to circulate.

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Positioning

This appliance is designed to operate in ambient temperatures between 16 It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a cooker or other sources of direct heat, or in a very cold room e.g. an outhouse, where the temperatures may fall below

° C (60 ° F). If these temperatures are exceeded i.e.

16 colder or warmer, then the appliance may not operate correctly.

For building-in and door reversibility, if necessary, refer to the relevant instructions in the following pages.

° C (60 ° F) and 32 ° C (90 ° F).

Before using

Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.

The electrical connections

WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety

measure not be observed.

If the plug that is ﬁtted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug ﬁtted.

Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home.

Important

The wires in the mains lead are coloured in accordance with the following code:

Green and Yellow - Earth Blue - Neutral Brown - Live

If you ﬁt your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug, proceed as follows:

A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose address is listed in the Customer Care Booklet which accompanies your instruction manual.

This appliance complies with the E.E.C. Directive No. 87/308 of 2.6.87 relative to radio interference suppression.

This appliance complies with the following E.E.C. Directives:

73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modiﬁcations;

89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent modiﬁcations.

Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.

Fig. 1

GREEN & YELLOW

BLUE

D207

13 AMP. FUSE

13 AMP

BROWN

CORD CLAMP

Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yellow.

Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.

Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.

The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug.

+ 11 hidden pages