Zanussi ZBF669SX, ZBF669SW User Manual

BUILT-IN OVEN
ZBF 669
INSTRUCTION BOOKLET
Please read this instruction booklet before using the appliance
GB
Important Safety Information
You MUST read these warnings carefully before installing or using the oven. If you need assistance, contact our Customer Care Department on 08705 727727
Installation
the relevant British Standards.
This oven is heavy. Take care when moving it.
Remove all packaging, both inside and outside the
oven, before using the oven.
Do not attempt to modify the oven in any way.
Child Safety
This oven is designed to be operated by adults. Do not
allow children to play near or with the oven.
The oven gets hot when it is in use. Children should be
kept away until it has cooled.
During Use
This oven is intended for domestic cooking only. It is
not designed for commercial or industrial purposes.
Never line any part of the oven with aluminium foil.
Maintenance and Cleaning
Only clean this oven in accordance with the instructions.
The oven should be kept clean at all times. A build-up
of fats or other foodstuffs could result in a fire, especially in the grill pan.
Always allow the oven to cool down and switch off the
electrical supply before carrying out any cleaning or maintenance work.
Service
This oven should only be repaired or serviced by an
authorised Service Engineer and only genuine approved spare parts should be used.
Environmental Information
After installation, please dispose of the packaging
with due regard to safety and the environment.
When disposing of an old appliance, make it unusable,
by cutting off the cable. Remove any door catches, to prevent small children being trapped inside.
Do not allow heatproof cooking material, e.g. roasting
bags, to come into contact with oven elements.
Never place plastic or any other material which may
melt in or on the oven.
Do not place sealed cans or aerosols inside the oven.
They may explode if they are heated.
Do not hang towels, dishcloths or clothes from the
oven or its handle.
Do not use this oven if it is in contact with water and
never operate it with wet hands.
Take great care when heating fats and oils as they will
ignite if they become too hot.
Always use oven gloves to remove and replace food in
the oven.
Ensure that all control knobs are in the OFF position
when not in use.
Do not leave cookware containing foodstuffs, e.g. fat
or oil in or on the oven in case it is inadvertently switched ON.
When using other electrical appliances, ensure the
cable does not come into contact with the hot surfaces of the oven.
Keep this instruction book for future reference
and ensure it is passed on to any new owner.
2
Content s
For the User
Important Safety Information 2
Description of the Oven 4
Controls 5
Electronic programmer 6
Before the First Use 8
Using the Oven 8
Hints and Tips 9
Using the Conventional Oven 10
The Fan Oven 12
Grilling 14
Defrosting 15
Cleaning the Oven 16
Replacing the Oven Light 17
Cleaning the hinged grill 17
Service and Spare Parts 18
For the Installer
Installation 20
Electrical Connection 20
Building In 21
Oven Door Protection Device
(stainless steel models only)
All our appliances comply with the European safety standards. Nevertheless, in order to ensure the highest safety level, and avoid little children to be exposed to the heat when the appliance is operated, it is possible to fit a special ptotection device to the oven door. This device can be purchased in our Service Force Centres, specifying the relevant code ( 357828401/4) and the Product No. shown on the rating plate.
Something not working 18
Customer Care 19
Guarantee Conditions 19
Guide to use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
Step by step instructions for an operation
F
Hints and Tips
Environmental information
This appliance complies with the following E.E.C.
Directives: *73/23 - 90/683 (Low VoltageDirective); *93/68 (General Directives); *89/336 (Electromagnetical Compatibility Directive)
and subsequent modifications.
3
Description of the Oven
Electronic programmer
Mains on Light
Thermostat
Control Light
Thermostat Control Knob Oven Function Control Knob
Grill Element
Oven Light
Fan
Rating Plate
Oven accessories
Grill/roasting
pan
Removable
handles
Grill trivet
Anti-tip shelf (x 2)
4
Controls
Oven Function Control Knob
Conventional cooking - The heat comes from both the top and bottom element, ensuring even heating
inside the oven
Bottom heating element - The heat comes from the bottom of the oven only
Fan cooking - This allows you to roast or roast and bake simoultaneously using any shelf, without
flavour transference
Inner grill element only - Can be used for grilling small quantities
Full Grill - The full grill element will be on
Defrost Setting - This setting is intended to assist
in thawing of frozen food.
Mains on Light
The mains on light will come on when the oven function control knob is set.
0
FO 2676
Thermostat Control Knob (°C)
Turn the thermostat control knob clockwise to select temperatures between 50°C and 250°C (MAX).
Thermostat Control Light
The thermostat control light will come on when the thermostat control knob is turned. The light will remain on until the correct temperature is reached. It will then cycle on and off to show the temperature is being maintained.
The Safety Thermostat
This oven is provided with a safety thermostat. In case of malfunctioning of the main thermostat, and consequent over-heating, the safety device will stop the power supply to the appliance. If this happens, call your local Service Force Centre. Under no circumstances should you attempt to repair the appliance yourself.
50
MAX
100
200
150
FO 2673
5
Electronic programmer
4
1. Push button for selecting a function
5 6
23
The oven will work only if the time of day has been set.
However, the oven can also be operated without any programme.
1
Setting the time of day
7 8
FO 2571
2. Decreasing control button 
3. Increasing control button  
4. Display
5. Cooking Duration pilot lamp
6. End of cooking pilot lamp
7. Minute minder pilot lamp
8. Time of day pilot lamp
When the power supply is switched on, or after a power failure, the Time of day pilot lamp will flash on the display.
To set the correct time of day:
1. Press button   or  .
2. After the setting is carried out, wait for 5 seconds: the Time of day pilot
lamp will go out and the display will show the set time. The appliance is ready for use.
To reset the correct time of day:
1. Press button repeatedly to select the Time of day function. The
relevant pilot lamp will start flashing. Then proceed as described above. The time of day can only be reset if no automatic function (cook duration
or end of cooking ) has been set.
Cooking Duration function
This function allows the oven to automatically switch off at the end of a programmed cooking duration time. Place food in the oven, select a cooking function and adjust the cooking temperature. Press button repeatedly to select the Cooking Duration function. The relevant pilot lamp will start flashing. Then, proceed as follows:
To set the duration time:
1. Press button   or  .
2. After the setting is carried out, wait for 5 seconds: the "Cooking Duration"
pilot lamp will come on and the display will revert to the time of day.
3. When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the oven function and the thermostat control knob to zero. To switch off the acoustic alarm, press any button. NOTE: turning the acoustic alarm off will reset the oven to manual, and if the oven function and the thermostat knobs are not set to zero the oven will start to heat again.
To cancel the duration time:
1. Press button repeatedly to select the Cooking Duration function.
The relevant pilot lamp will flash and the display will show the remaining cooking time.
2. Press button   until the display shows 0:00. After 5 seconds the pilot lamp will go out and the display will revert to the time of day.
6
End of cooking function
Thanks to this function, you can set the oven to switch off automatically when a programmed end of cooking time is over. Place food in the oven, select a cooking function and adjust the cooking temperature. Press button repeatedly to select the End of cooking function. The relevant pilot lamp will start flashing. Then, proceed as follows:
To set the End of cooking time:
1. Press button   or  .
2. After the setting is carried out, wait for 5 seconds: the End of cooking pilot
lamp will come on and the display will revert to the time of day.
3. When cooking time is over, the oven will be switched off automatically and an acoustic alarm will be heard, while the pilot lamp will start flashing. Turn the oven function and the thermostat control knob to zero. To switch off the acoustic alarm, press any button. NOTE: turning the acoustic alarm off will reset the oven to manual, and if the oven function and the thermostat knobs are not set to zero the oven will start to heat again.
To cancel the End of cooking time:
1. Press button repeatedly to select the End of cooking function. The
relevant pilot lamp will flash and the display will show the programmed End of cooking time.
2. Press button   until the display shows the current time of day. The programmer will beep and the pilot lamp will go out.
Cooking duration and End of cooking time combined
The functions Cooking duration and End of cooking time can be used
simultaneously to set the oven to switch on and off automatically at a later time.
1. With the Cooking duration function (carry out the cooking duration setting as described in the relevant chapter) set the duration time. Then, press button
: the display will show the programmed setting.
2. With the End of cooking time function (carry out the End of cooking setting as described in the relevant chapter) set the end of cooking time. The relevant pilot lamps will come on and the display will show the time of day. The oven will switch on and off according to the set programmes.
Minute minder function
The minute minder alarm will sound at the end of a timed period, but THE OVEN WILL REMAIN ON, if it is in use.
To set the minute minder:
1. Press button repeatedly to select the Minute minder function. The relevant
pilot lamp will start flashing.
2. Then, press button   or   (maximum: 2 hours, 30 minutes).
3. After the setting is carried out, wait for 5 seconds: the Minute minder pilot
lamp will come on.
4. At the end of the timed period, the pilot lamp will start flashing and an acoustic alarm will be heard. To switch off the acoustic alarm, press any button.
To cancel the minute minder:
1. Press button repeatedly to select the Minute minder function. The relevant
pilot lamp will flash and the display will show the remaining time.
2. Press button   until the display shows 0:00. After 5 seconds the pilot lamp will go out and the display will revert to the time of day.
How to switch off the display
1. Press two or three programmer push buttons simoultaneously and keep them pressed for about 5 seconds. The display will switch off.
2. To switch on the display, press any button.
The display can be switched off only if no other functions have been set.
7
Before the First Use
Remove all packaging, both inside and outside the oven, before using the oven.
Before first use, the oven should be heated without food. During this time, an unpleasant odour may be emitted. This is quite normal.
The oven will work only if the time of day has been set.
1. Set the time of day with the electronic programmer (see chapter "Electronic Programmer").
2. Switch the oven function control knob to conventional
cooking .
3. Set the thermostat control knob to MAX.
4. Open a window for ventilation.
5. Allow the oven to run empty for approximately 45 minutes.
This procedure should be repeated with the grill
function and the fan cooking function for approximately 5-10 minutes.
Using the Oven
Always cook with the oven door closed.
Stand clear when opening the oven door.
The oven has four shelf levels, counted from the bottom, as shown in the diagram. Your oven is supplied with two anti-tip shelves.
It is important that these shelves are correctly positioned as shown in the diagram.
Shelf level 2 is fitted with telescopic shelf supports.
Do not place cookware directly on the oven base.
The cooling fan
The cooling fan operates during cooking. Air is expelled through vents between the oven door and the control panel, as shown in the diagram. The cooling fan may run on after the oven is switched off to keep the controls cool. This is quite normal.
4
3
2
1
FO 2259
8
Loading...
+ 17 hidden pages