YOKOGAWA AXFA11G User Manual

User’s Manual

AXFA11G Magnetic Flowmeter Remote Converter [Hardware Edition/Software Edition]

Manual Change No. 06-015-1E

Please use the attached sheets for the pages listed below in IM 01E20C01-01E (5 th).

Page and Item Contents of Correction

Page 5-3

5.2 Display Unit Setting Methods Changed the note of entry mode.

Yokogawa Electric Corporation

Dec. 4, 2006

5.2 Display Unit Setting Methods

NOTE

Before changing any settings, be sure to check the corresponding setting details in Chapter 6: Parameter Description.

5.2.1 Display Mode → Setting Mode

Display Mode will be adopted when the power is turned on, and the Setting Mode can be activated using the following procedure.

Parameter Search Mode

(2 seconds or more)

Display Mode

Entry Mode

Select “Yes”

Major Item Parameter

Search Mode

5. BASIC OPERATING PROCEDURES

Sub-item Parameter

Search Mode

Parameter

Replacement Mode

Start:

Display Mode

Select “No”

Press the SET switch while holding down the SHIFT switch.

+ +

Setting modes

* The term "mode" is used to refer to a situation where display and setting are possible.

F0502.EPS

Sample Display: Procedure for moving from Display Mode to Setting Mode

1st line: Actual instantaneous flow rate [FR] 2nd line: Bar graph indicating instantaneous flow

: : :

3274m

FTL

100

rate 3rd line: Totalized forward flow rate [FTL]

Setting switches

Hold the switch for 2 seconds.

Entry Mode

(*1)

Touch SHIFT + key

F0503-1.EPS

Touch and switches simultaneously.

(*1)

The Major Item Parameter which is set just before will be shown when entrying the Setting Mode again within 1 minute after returning from Setting Mode to Display Mode.

5-3

IM 01E20C01-01E