YOKOGAWA 701983 User Manual
User’s
Manual
9OKOGAWA%LECTRIC#ORPORATION
IM 701983-01E 1/2
1st Edition
1st Edition : March 2007 (YK)
All Rights Reserved, Copyright © 2007 Yokogawa Electric Corporation
Model 701983
RACK MOUNTING KIT
For an EIA-compliant Single-housing Rack
1. Checking the Parts in the Kit
Confirm that all parts listed below are included in the kit. If any part is shorted or any abnormality is found in
the appearance of the parts, contact our sales representative where you bought the instrument.
List of parts included in the kit.
right side bracket (1pc), left side bracket (1pc), screws (M5, 8 mm long) (4pcs)
2. Joining the Instruments with Mounting Hardware
1. Distinguish between the left and right side brackets. If the projection of the bracket end is turned
downward, distinction on either side can be performed easily.
2. Remove sealing label (b) from the left and right sides of the instrument (4 labels).
3. If the four feet on the botton of the instrument are covered with rubber stoppers, remove all of them.
4. Attach the left side bracket (a) to the left side of the instrument with two frame attachment screws (d).
Reference torque value: 2.8 to 2.9 N∙m
5. Attach the right side bracket (b) to the right side of the instrument with two frame attachment screws (d).
Reference torque value: 2.8 to 2.9 N∙m
d
d
d
d
c
c
c
c
a
b
Projection
Projection
IM 701983-01E 2/2
3. Mounting the Joined Instruments to the Rack
Dimensions after mounting to the rack are illustrated below.
Note:
1. Be sure to support the instrument from the bottom. When doing so, make sure not to cover the
ventilation holes on the bottom of the instrument.
2. Provide a clearance of at least 100 mm around the instrument to prevent the temperature rise inside
the instrument.
(
10.89
)
276.7
(
0.31
)8(
0.44
)
11.2
(
19.00
)
482.6
(
18.12
)
460.2
(
1.48
)
37.7
(
0.10
)
2.5
(
2.25
)
57.1
(
3.00
)
76.2
(
2.25
)
57.2
(
10.47
)
265.9
Unit : mm
(approx. inch)
Loading...