Yamaha MNM5000, MNR5000, STM5000, STR5000, SAM5000 User Manual

FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS
UNIT!

This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirements. Modifications not expressly
approved by Yamaha may void your authority,
granted by the FCC, to use the product.

2. IMPORTANT: When connecting this product to

accessories and/or another product use only high
quality shielded cables. Cable/s supplied with this
product MUST be used. Follow all installation
instructions. Failure to follow instructions could void
your FCC authorization to use this product in the
USA.

3. NOTE: This product has been tested and found to

comply with the requirements listed in FCC Regu­lations, Part 15 for Class “B” digital devices. Com­pliance with these requirements provides a
reasonable level of assurance that your use of this
product in a residential environment will not result
in harmful interference with other electronic
devices. This equipment generates/uses radio fre­quencies and, if not installed and used according
to the instructions found in the users manual, may
cause interference harmful to the operation of

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its
subsidiaries.

* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B)

other electronic devices. Compliance with FCC
regulations does not guarantee that interference
will not occur in all installations. If this product is
found to be the source of interference, which can
be determined by turning the unit “OFF” and “ON”,
please try to eliminate the problem by using one of
the following measures:

Relocate either this product or the device that is
being affected by the interference.

Utilize power outlets that are on different branch
(circuit breaker or fuse) circuits or install AC line fil­ter/s.

In the case of radio or TV interference, relocate/
reorient the antenna. If the antenna lead-in is 300
ohm ribbon lead, change the lead-in to co-axial
type cable.

If these corrective measures do not produce satis­factory results, please contact the local retailer
authorized to distribute this type of product. If you
can not locate the appropriate retailer, please con­tact Yamaha Corporation of America, Electronic
Service Division, 6600 Orangethorpe Ave, Buena
Park, CA90620

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.