Yamaha RS502 User Manual

RS502

ELECTRONIC DRUM RACK RACK DE BATTERIE ÉLECTRONIQUE

Owner’s Manual Bedienungsanleitung Mode d’emploi

取扱説明書

䏳淑㏭㙴

電子ドラムラック

EnglishDeutschFrançais

English

PRECAUTIONS

Before using, please read this assembly manual, and use this product in a safe and proper manner.

* Please keep this manual in a safe place for future reference.

WARNING

• Do not let small children assemble or set up this product by themselves, or they may be injured. Always assemble this product with adult supervision.

• Be careful with the edges of the Cymbal Holders and the Tom Holders. The sharp holder ends may result in injury.

• If this product is used with a Rack System or Cymbal Stand, make sure all bolts are tightened firmly. Also, when adjusting the height or angle, do not suddenly loosen the bolts. Loose bolts may result in the rack overturning or parts dropping, causing injury.

• Always set the product on a flat and solid surface. Placement on a sloping, unstable surface or on steps may result in the product being unstable and subject to overturning.

• Do not alter the product. Doing so may result in injury or damage/deterioration to the product.

• Do not sit or step on the rack. The rack may overturn or be damaged, resulting in injury.

CAUTION

• Watch your fingers when adjusting clamps. They may become pinched, resulting in injury.

• Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. may injure your fingers.

• Do not attach acoustic drums to the electronic drum rack. Clamps may be damaged and drums may drop, causing injury.

If this symbol is ignored and the equipment is used improperly, fatal injury to persons or serious damage could occur.

If this symbol is ignored and the equipment is used improperly, there is a danger or injury to persons handling the equipment, and material damage could occur.

NOTICE

• Do not step on or place heavy objects on the product. It may result in damage.

• Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc.) or high humidity (bathroom, outside on a rainy day, etc.). Doing so may result in deformation, discoloration, damage or deterioration.

• When cleaning the product, do not use benzine, thinner or alcohol as it may result in discoloration or deformation. Please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. If the product is soiled or sticky, use a neutral detergent on a cloth then wipe with a damp cloth that has been wrung out thoroughly to remove any remaining detergent. Also pay close attention so as not to let the water and detergent come into contact with the cushions used in the product; doing so may result in deterioration.

RS502 Owner’s Manual

Package Contents

Main frame (x1) Left arm (x1)

Right arm (x1)

Left leg (x1) Right leg (x1) Tom holder (x3)

Cymbal holder (x2) Snare holder (x1) Owner’s Manual

(this booklet)

After opening up the package containing your electronic drum rack, please verify that all of the following components are present.

RS502 Owner’s Manual

 Fully-assembled rack

Left arm

Clamp r

Clamp e

Clamp w

Clamp t

Right arm

Left leg Right leg

Main frame

Clamp q

RS502 Owner’s Manual

Assembling the Rack

Clamp q Clamp w

Screw

Tuning key

Clamp q

Clamp e

Center strut Clamp w

Loosen

Bolt

Lightly tighten

Left arm Clamp r

Screw

1. Lay the main frame down on a solid, level surface and loosen the screws in clamps q and w using the

tuning key.

NOTE

The tuning key can be found in the pad set package.

2. Loosen the bolts on clamps q, w, and e and move the clamps all the way down to the center strut.

Following this, lightly tighten the clamp bolts.

3. Take the left arm from the package and loosen the screw in clamp r using the tuning key.

The left and right arms look very alike, but the left arm is longer. Take care not to mix them up when assembling the rack.

RS502 Owner’s Manual

+ 9 hidden pages