Yamaha HY256-TL, HY256-TL-SMF Owner's Manual
JA
ES
KO
ZH
RU
IT
PT
FR
DE
EN
EnglishDeutschFrançaisEspañol
Português
ItalianoРусский中文ଛ˯ߪ日本語
Owner’s Manual
Bedienungsanleitung
Mode d’emploi
Manual de instrucciones
Manual do Proprietário
Manuale di istruzioni
Руководство пользователя
使用说明书
یࡈ۶ָ۰
取扱説明書
AUDIO INTERFACE CARD
HY
256
-
TL
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT
MODIFY THIS UNIT!
This product, when installed as indicated in
the instructions contained in this manual,
meets FCC requirements. Modific ations not
expressly approved by Yamaha may void
your authority, granted by the FCC, to use
the product.
2. IMPORTANT: When connecting this
product to accessories and/or another
product use only high quality shielded
cables. Cable/s supplied with this pr oduct
MUST be used. Follow all installation
instructions. Failure to follow instructions
could void your FCC authorization to use
this product in the USA.
3. NOTE: This product has been tested and
found to comply with the requirements
listed in FCC Regulations, Part 15 for Class
“B” digital devices. Compliance with t hese
requirements provides a reasonable level
of assurance that your use of this product
in a residential environment will not result
in harmful interference with other electronic
devices. This equipment generates/uses
radio frequencies and, if not installed and
used according to the instructions found in
the users manual, may cause interference
harmful to the operation of other electronic
* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. (class B)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
devices. Compliance with FCC regulations
does not guarantee that interference will
not occur in all installations. If this product
is found to be the source of interference,
which can be determined by turning the
unit “OFF” and “ON”, please try to eliminate
the problem by using one of the following
measures:
Relocate either this product or the device
that is being affected by the interference.
Utilize power outlets that are on different
branch (circuit breaker or fuse) circuits or
install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna
lead-in is 300 ohm ribbon lead, change the
lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact
the local retailer authorized to distribute this
type of product. If you can not locate the
appropriate retailer, please contact Yamaha
Corporation of America, Electronic Service
Division, 6600 Orangethorpe Ave, Buena
Park, CA90620
The above statements apply ONLY to those
products distributed by Yamaha Corporation of America or its subsidiaries.
CAN ICES-3 (B)/NMB-3(B)
• This applies only to products distributed by Yamaha Canada Music Ltd.
• Ceci ne s’applique qu’aux prod uits distribués par Yamaha Canada Musique Ltée.
HY256-TL Owner’s Manual
2
(can_b_01)
PACARD_en_1 1/2
PRECAUTIONS
PLEASE READ CAREFULLY BEFORE PROCEEDING
Please keep this manual in a safe place for future reference.
WARNING
Always follow the basic precautions listed below to avoid the possibility of
serious injury or even death from electrical shock, short-circuiting,
damages, fire or other hazards. These precautions include, but are not
limited to, the following:
• Do not attempt to disassemble or modify the card. Do not apply excessive force to
card connectors or other card components. Mishandling of the card may lead to
shock, fire hazard, or device failure.
• Be sure to disconnect the power cable of the host device before installing the card
and connecting/disconnecting the cables (in order to eliminate shock hazard,
undesired noise, and avoid device damage).
• Turn off all peripheral devices connected to the host device before installation, and
unplug all related cables.
• Do not use burning items near the device. It may cause a fire.
CAUTION
Always follow the basic precautions listed below to avoid the possibility of
physical injury to you or others, or damage to the device or other property.
These precautions include, but are not limited to, the following:
• Be sure to properly ground the host device to prevent electrical shock and/or
malfunction.
• Do not touch the metallic leads (pins) of the circuit board when handling the card.
The pins are sharp and may cause hand cuts.
• Wear a pair of heavy gloves during installation to avoid scratching or cutting your
hands on sharp edges.
• Do not place the device in a location where it may come into contact with corrosive
gases or salt air. Doing so may result in malfunction.
• Do not look at the laser light. This product uses a laser. Be careful to avoid looking at
the ends of the optical fibers or the optical connectors. In the event you look at the
laser, it may damage your eyes.
HY256-TL Owner’s Manual
3
PACARD_en_1 2/2
Yamaha cannot be held responsible for damage caused by improper use or
modifications to the device, or data that is lost or destroyed.
NOTICE
To avoid the possibility of malfunction/ damage to the product, damage to data, or
damage to other property, follow the notices below.
• Avoid touching exposed connectors and metal parts to minimize the possibility of
bad connections.
• Drain all static electricity from your clothing and body before handling the card.
Static electricity can damage the card. Touch an exposed metal part of the host
device or other grounded object beforehand.
• Do not drop the card or subject it to physical shock as this can result in breakage
and/or malfunction.
Handling and maintenance
• Do not expose the device to excessive dust or vibration, or extreme cold or heat
(such as in direct sunlight, near a heater, or in a car during the day), in order to
prevent the possibility of panel disfiguration, unstable operation, or damage to the
internal components.
• Do not place vinyl, plastic or rubber objects on the device, since this might discolor
the panel.
• When cleaning the device, use a dry and soft cloth. Do not use paint thinners,
solvents, cleaning fluids, or chemical-impregnated wiping cloths.
• Condensation can occur in the device due to rapid, drastic changes in ambient
temperature — when the device is moved from one location to another, or air
conditioning is turned on or off, for example. Using the device while condensation is
present can cause damage. If there is reason to believe that condensation might
have occurred, leave the device for several hours without turning on the power until
the condensation has completely dried out.
HY256-TL Owner’s Manual
4
Information
About functions/data bundled with the device
• This product is a class 1 laser product. It is compliant with IEC60825-1, IEC60825-2,
FDA 21 CFR 1002.10, and 1002.12.
About this manual
• The illustrations as shown in this manual are for instructional purposes only.
• The company names and product names in this manual are the trademarks or
registered trademarks of their respective companies.
European Models
Purchaser/User Information specified in EN55103-1:2009 and EN55103-2:2009.
Conforms to Environments: E1, E2, E3 and E4.
HY256-TL Owner’s Manual
5
Contents
PRECAUTIONS ...........................................................3
NOTICE........................................................................4
Introduction ................................................................ 7
Main Features .............................................................7
Installation ...................................................................7
Accessories ................................................................7
Part Names and Functions........................................ 8
Specifications....................... (at the end of the book)
Dimensions........................... (at the end of the book)
HY256-TL Owner’s Manual
6
Introduction
Thank you for choosing a Yamaha HY256-TL Audio Interface Card. The
HY256-TL is a digital I/O card for HY card slots, and compatible with
Yamaha’s TWINLANe* audio network protocol.
To take full advantage of the superior features and performance offered by
your HY256-TL, and to enjoy years of trouble-free use, please read this
owner’s manual carefully before using your card. After you have read the
manual, keep it in a safe place.
* TWINLANe can transmit audio signals over a maximum of 400 channels and control
signals via a single cable. Refer to the RIVAGE PM10 Operation Manual for details.
Main Features
• Can send and receive uncompressed digital audio signals of 32-bit
96 kHz quality via multi-mode optical fiber cable, with a maximum of 256
inputs/256 outputs.
• Redundant connections are supported with ring topology.
• Indicators show communication status useful for troubleshooting.
Installation
Refer to the leaflet included with the card for installation.
Refer to the owner’s manual supplied with each device for more information
about installation and removal.
Accessories
• Owner’s Manual (this document)
• Card installation instructions leaflet
HY256-TL Owner’s Manual
7
Loading...