CD-S303RK
CD-S303
Update Guide
Manual Development Group
© 2021 Yamaha Corporation
Published 10/2021
IPOD-A0
VFQ0270
Compact Disc Player
Note
Updating the firmware
Follow the steps below to update the firmware of the unit.
Checking the firmware version of the unit
Turn on the unit.
1
If the USB indicator on the front panel is lit, press CD/USB to switch
2
to Disc mode.
If a CD has been placed on the disc tray, remove it.
Press and hold A/B on the remote control.
3
The current firmware version appears on the information display of the front panel
for about five seconds. Write down the version number.
Downloading the firmware
Have the following items ready.
1
• USB flash drive: Use a USB flash drive that meets all of the following
requirements.
– Supports the USB mass storage device class
– Formatted in FAT16 or FAT32 format
– No encryption applied
– No data stored on the device (empty)
• Computer that can be connected to the Internet
Download the firmware.
2
Check the version number of the latest firmware uploaded on the product pages of
Yamaha website. Download the firmware to update only if it is newer than that of
the unit.
Save the firmware data file to the USB flash drive.
3
Decompress the downloaded file and save the firmware data file in a folder at the
highest level of hierarchy (i.e., the root folder) of the USB flash drive.
• Do not change the file name when saving the firmware data file to the USB flash drive.
1
Updating the firmware
Notice
Operate the unit to update the firmware.
Press CD/USB to switch to USB mode.
1
Connect the USB flash drive to the USB jack on the front panel.
2
“UNSUPPORT” appears on the information display of the front panel.
Press and hold (Pause).
3
“UPGRADE” appears on the information display of the front panel, and the unit
starts updating its firmware. The updating process takes about 20 seconds to
complete. When the process completes, the unit automatically restarts.
• Do not turn off the power to the unit while updating. Turning off the power while updating the
firmware may cause damage to the unit.
Press CD/USB to switch to Disc mode.
4
Press and hold A/B on the remote control.
5
Make sure that the firmware version indicated on the display is the same as that of
the downloaded firmware.
Turn off the unit and remove the USB flash drive.
6
Troubl eshooting
If the “UPGRADE” stays on the information display for one minute or longer
The update process might have failed. Turn off the unit and remove the USB flash drive.
Make sure that the following requirements are satisfied, and then perform the operation
from step 1 of “Updating the firmware” again.
– The firmware data file has been saved in a folder at the highest level of hierarchy
(i.e., the root folder) of the USB flash drive.
– The data file name of the firmware has not been changed.
2
Loading...