XPiQ inc PUP110-10, PUP110-12, PUP110-45, PUP110-45-1, PUP110-45-2 Datasheet

...
AC/DC External Desktop
110 Watts
PUP110 Series
Specification
All specifications typical at nominal line, full load and 25°C
Input
Input Voltage 85-264 VAC Input Frequency 47 to 440 Hz Input Current 3.20 A (rms) for 115 VAC
1.80 A (rms) for 230 VAC
Output
Output Voltage See Tables Output Current See Tables Ripple and Noise 1% pk-pk max Overvoltage Provided on output #1 only
Protection set at 112-132% of its nominal
output voltage Overcurrent All outputs protected to short Protection: circuit conditions
Temperature All outputs ±0.04%/°C Coefficient: maximum
Power Fail Detect TTL logic high for normal (optional) operation and TTL logic low
upon loss of input power. This
signal appears at least 1 ms prior
to +5 V output dropping 5% below
its nominal value. This signal also
provides a minimum delay of
100 ms after +5 V is within
regulation
XPiQ inc.
Intelligent Design Quality Product
International Safety Approvals
Wide Input Voltage 85 to 264 VAC
General
Efficiency 62% minimum at 110 W output Hold-up time 12 msec minimum Line Regulation ±0.5% maximum at full load Inrush Current 15 A at 115 VAC or
Withstand Voltage 3000 VAC from input to output
Insulation Resistance • 10 Mohm minimum from
Environmental
Operating 0 °C to +70 °C derate linearly from Temperature 100% load at +50 °C to 50% load
Storage -40 °C to +85 °C Temperature
MTBF 100,000 hours minimum at full load
EMC & Safety
EMI Requirements Meets conducted limits of
Safety Requirements • Approved to:
Built-in EMI Filter
with CE Mark
100% Burn-In
3000 VAC Isolation
Input Surge Protection
30 A at 230 VAC at +25 °C cold start
1500 VAC from input to ground 500 VAC from output to ground
output to ground
at +70 °C
at +25 °C ambient
FCC 20780 Level B, CISPR 22 (EN 55022) Level B
a) UL 1950 b) CSA C22.2 No. 234 c) IEC 950
www.XPiQ.com
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA
OUTPUT VOLTAGE & CURRENT RATINGS PUP110
Output #1 Output #2 Output #3 Output #4 Model
Vnom Imin Imax Tol. Vnom Imin Imax lpeak Tol. Vnom Imin Imax Tol Vnom Imin Imax Tol Number
5 V 0 A 22.0 A 5% PUP110-10 12 V 0 A 9.0 A 4% PUP110-12 15 V 0 A 7.5 A 3% PUP110-13 24 V 0 A 4.5 A 3% PUP110-14 30 V 0 A 3.6 A 3% PUP110-16 48 V 0 A 2.3 A 3% PUP110-18 +5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% PUP110-23 +5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% PUP110-31 +5 V 0 A 10.0 A 5% +15 V 0 A 4 A 7.5 A 5% -15 V 0 A 1 A 5% PUP110-32 +5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% -5 V 0.0 A 1 A 5% PUP110-40 +5 V 0 A 10.0 A 5% +15 V 0 A 4 A 7.5 A 5% -15 V 0 A 1 A 5% +24 V 0.0 A 1 A 5% PUP110-41 +5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% +12 V 0.0 A 1 A 5% PUP110-42 +5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% +24 V 0.0 A 1 A 5% PUP110-45 +5 V 2 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% +24 V 1.5 A 3 A 10% PUP110-45-1 +5 V 0 A 10.0 A 5% +24 V 0 A 3 A 5.0 A 5% -12 V 0 A 1 A 5% +12 V 0.0 A 1 A 5% PUP110-45-2 +5 V 0 A 10.0 A 5% +15 V 0 A 4 A 7.5 A 5% -15 V 0 A 1 A 5% -5 V 0.0 A 1 A 5% PUP110-46
Pin Chart
Model 1 2 3 4 5 6 7 8 PUP110-10 PUP110-12 Common Common Output Common Output Common Output PUP110-13 PUP110-14 Return Return #1 Return #1 Return #1 PFD PUP110-16 PUP110-18
PUP110-23 Common N.C. Output N.C. Output Common Output PFD
PUP110-31 PUP110-32 Common Output Output N.C Output Common Output PFD
PUP110-40 PUP110-41 PUP110-42 PUP110-45 Common Output Output OUTPUT Output Common Output PFD PUP110-45-1 PUP110-45-2 Return #3 #1 #4 #2 Return #1 PUP110-46
Return #1 #2 Return #1
Return #3 #1 #2 Return #1
Mechanical Details
NOTE:
1. Dimensions shown in inches (mm).
2. Tolerance 0.02 (0.5) maximum.
3. Optional output connectors available.
4. Optional ON/OFF switch available.
5. Weight: 1.35 kg .
www.XPiQ.com
*AMP Receptacle No. 212047-1 or Equivalent
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA
Loading...