AC/DC External Desktop
110 Watts
PUP110 Series
Specification
All specifications typical at nominal line, full load and 25°C
Input
Input Voltage • 85-264 VAC
Input Frequency • 47 to 440 Hz
Input Current • 3.20 A (rms) for 115 VAC
1.80 A (rms) for 230 VAC
Output
Output Voltage • See Tables
Output Current • See Tables
Ripple and Noise • 1% pk-pk max
Overvoltage • Provided on output #1 only
Protection set at 112-132% of its nominal
output voltage
Overcurrent • All outputs protected to short
Protection: circuit conditions
Temperature • All outputs ±0.04%/°C
Coefficient: maximum
Power Fail Detect • TTL logic high for normal
(optional) operation and TTL logic low
upon loss of input power. This
signal appears at least 1 ms prior
to +5 V output dropping 5% below
its nominal value. This signal also
provides a minimum delay of
100 ms after +5 V is within
regulation
XPiQ inc.
Intelligent Design Quality Product
•
International Safety Approvals
Wide Input Voltage 85 to 264 VAC
General
Efficiency • 62% minimum at 110 W output
Hold-up time • 12 msec minimum
Line Regulation • ±0.5% maximum at full load
Inrush Current • 15 A at 115 VAC or
Withstand Voltage • 3000 VAC from input to output
Insulation Resistance • 10 Mohm minimum from
Environmental
Operating • 0 °C to +70 °C derate linearly from
Temperature 100% load at +50 °C to 50% load
Storage • -40 °C to +85 °C
Temperature
MTBF • 100,000 hours minimum at full load
EMC & Safety
EMI Requirements • Meets conducted limits of
Safety Requirements • Approved to:
Built-in EMI Filter
•
with CE Mark
•
100% Burn-In
•
3000 VAC Isolation
•
Input Surge Protection
•
30 A at 230 VAC at +25 °C cold start
1500 VAC from input to ground
500 VAC from output to ground
output to ground
at +70 °C
at +25 °C ambient
FCC 20780 Level B, CISPR 22
(EN 55022) Level B
a) UL 1950
b) CSA C22.2 No. 234
c) IEC 950
•
www.XPiQ.com
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA
•
OUTPUT VOLTAGE & CURRENT RATINGS PUP110
Output #1 Output #2 Output #3 Output #4 Model
Vnom Imin Imax Tol. Vnom Imin Imax lpeak Tol. Vnom Imin Imax Tol Vnom Imin Imax Tol Number
5 V 0 A 22.0 A 5% PUP110-10
12 V 0 A 9.0 A 4% PUP110-12
15 V 0 A 7.5 A 3% PUP110-13
24 V 0 A 4.5 A 3% PUP110-14
30 V 0 A 3.6 A 3% PUP110-16
48 V 0 A 2.3 A 3% PUP110-18
+5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% PUP110-23
+5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% PUP110-31
+5 V 0 A 10.0 A 5% +15 V 0 A 4 A 7.5 A 5% -15 V 0 A 1 A 5% PUP110-32
+5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% -5 V 0.0 A 1 A 5% PUP110-40
+5 V 0 A 10.0 A 5% +15 V 0 A 4 A 7.5 A 5% -15 V 0 A 1 A 5% +24 V 0.0 A 1 A 5% PUP110-41
+5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% +12 V 0.0 A 1 A 5% PUP110-42
+5 V 0 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% +24 V 0.0 A 1 A 5% PUP110-45
+5 V 2 A 10.0 A 5% +12 V 0 A 5 A 9.0 A 5% -12 V 0 A 1 A 5% +24 V 1.5 A 3 A 10% PUP110-45-1
+5 V 0 A 10.0 A 5% +24 V 0 A 3 A 5.0 A 5% -12 V 0 A 1 A 5% +12 V 0.0 A 1 A 5% PUP110-45-2
+5 V 0 A 10.0 A 5% +15 V 0 A 4 A 7.5 A 5% -15 V 0 A 1 A 5% -5 V 0.0 A 1 A 5% PUP110-46
Pin Chart
Model 1 2 3 4 5 6 7 8
PUP110-10 PUP110-12 Common Common Output Common Output Common Output
PUP110-13 PUP110-14 Return Return #1 Return #1 Return #1 PFD
PUP110-16 PUP110-18
PUP110-23 Common N.C. Output N.C. Output Common Output PFD
PUP110-31 PUP110-32 Common Output Output N.C Output Common Output PFD
PUP110-40 PUP110-41
PUP110-42 PUP110-45 Common Output Output OUTPUT Output Common Output PFD
PUP110-45-1 PUP110-45-2 Return #3 #1 #4 #2 Return #1
PUP110-46
Return #1 #2 Return #1
Return #3 #1 #2 Return #1
Mechanical Details
NOTE:
1. Dimensions shown in inches (mm).
2. Tolerance 0.02 (0.5) maximum.
3. Optional output connectors available.
4. Optional ON/OFF switch available.
5. Weight: 1.35 kg .
www.XPiQ.com
*AMP Receptacle No. 212047-1 or Equivalent
PH: 508 429.9883
FAX: 800 226.2100
Email: sales@xpiq.com
Holliston, MA 01746 USA