Xerox Phase 6200 Regular Printer Maintenance

Phaser® 6200 Color Laser Printer

Copyright © 200 2 X e rox Corporation. All Rights Reserved. 14

Regular Printer Maintenance

Your printer needs little maintenance other than periodic cleaning of the density sensor and replacing
the following Cus tomer-Replaceable Cons umables (CRCs) and Custo mer-Replaceable Units (CRUs):

■ Toner cartridges (blac k, cyan, magenta and yellow) — see page 17

■ Imaging unit — see page 18

■ Transfer roller — see page 23

■ Fuser — see page 20

■ Feed rollers — see page 25

Order extra printer supplies when the printer’s fro nt panel display s a warning that th e co nsumable is
low or near the end of its life. You must replace the consumable when the front panel displays an error
message that the consumable is empty or at the end of its lif e. For part number information, refer to the
Supplies section of the Support Guide on the Interactive Documentation CD-ROM. To order
consumables and other supplies, visit the Phaser® 6200 Supplies a nd Accessories web site

. Each item

includes installation instructions in the package.

Caution

Keep the imaging unit out of direct sunlight. Otherwise, f a de d images, light areas or dark
bands may result. Do not place the printer near vents or dust-producing equipment.

Warning

Do not burn the old toner cartridges, the imaging unit, the transfer ro ller, or the fuser.

Cleaning the outside of the printer

You can clean the outside of the printer with a soft, damp well-wrung cloth. You can use a cloth
moistened with a mi ld neutral detergent to remove stains; do not spray detergent directly onto the
printer.

Warning

To prevent electric shock, turn the printer off and unplug the power cord bef ore cleaning the
printer.

Caution

Do not use a vacuum cleaner to clean the printer. Do not lubricate the printer with oil.

Regular Printer Maintenance

Phaser® 6200 Color Laser Printer 15

Cleaning the density sensor

The printer s tops printing when the density sensor is dirty. To clean the de nsity sensor :

1. Use the latch on th e front of the printer to open Front Door A.

2. Remove the transfer roller. Squeeze the orange tabs at both sides of the trans fer roller and gently

lift it out of the printe r.

3. Use a dry towel or cotton swab to wipe the density sensor.

6200-66

6200-23

6200-12

Regular Printer Maintenance

Phaser® 6200 Color Laser Printer 16

Caution

Do not use canne d a ir or isopropy l a lc ohol on the sensor.

4. Reinstall the transfer roller. Insert the rounded ends of the transfer roller into the curved black

guides inside the printer. Lock the transfer roller into the printer by pushing down on the orange
tabs until you hear a click.

5. Close the fro nt door.

6200-24

6200-25

6200-64

Replacing a Toner Cartridge

Phaser® 6200 Color Laser Printer 17

Replacing a Toner Cartridge

6-8x

1

2

4.2

2.1

4.1

2.2

4

Click
Declic
Clic
Klicken
Clic
Clique

Klik
Klick

6

Pull
Tirer
Tirare
Ziehen
Tirar
Puxe

Trek
Dra

5

3