Xerox D95-D110-D125 with built-in controller, D95-D110-D125 with EX Print Server, D95-D110-D125 with FreeFlow Print Server, D95, D136 with built-in controller User Manual
Xerox D95-D110-D125 with built-in controller, D95-D110-D125 with EX Print Server, D95-D110-D125 with FreeFlow Print Server, D95, D136 with built-in controller, D136 with EFI Fiery Controller, D136 with FreeFlow Print Server, D95A-D110-D125 with built-in controller, D95A-D110-D125 with EX Print Server, D95A-D110-D125 with FreeFlow Print Server, D110, D125, D136 User Manual
4 Illegal in the USA and Canada............................................................4-1
It’s illegal in the USA..........................................................................................................4-1
It’s illegal in Canada...........................................................................................................4-3
Xerox® D95/D110/D125/D136ii
Safety Guide
1
Notices and certifications
Warning markings
Warning
This symbol alerts users to areas of the product where there is the possibility of personal
injury.
Hot Warning
This symbol alerts users to areas of the product where there are heated surfaces, which
should not be touched.
Caution
This symbol alerts users to areas of the equipment, which require special attention to
avoid the possibility of personal injury or damage to the equipment.
Laser Warning
This symbol indicates a Laser is being used in the equipment and alerts the user to refer
to the appropriate safety information.
Safety Guide
1-1Xerox® D95/D110/D125/D136
Notices and certifications
Radio frequency emissions
FCC in the USA
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the Federal Communications Commission (FCC) Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his/her own expense.
Changes or modifications to this equipment not specifically approved by the Xerox
Corporation may void the user’s authority to operate this equipment.
Warning
Shielded cables must be used with this equipment to maintain compliance with FCC
regulations.
In Canada (ICES-003)
This Class “A” digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe “A” est conforme à la norme NMB-003 du Canada.
Regulatory information for RFID
This product generates 13.56 MHz using an Inductive Loop System as a Radio Frequency
Identification system device (RFID). This RFID device complies with the requirements
specified in FCC Part 15, Industry Canada RSS-210, European Council Directive 99/5/EC,
and all applicable local laws and regulations.
Operation of this device is subject to the following two conditions: 1) this device may
not cause harmful interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this equipment not specifically approved by Xerox
Corporation may void the user’s authority to operate this equipment.
Xerox® D95/D110/D125/D1361-2
Safety Guide
Notices and certifications
Safety extra low voltage approval
This Xerox product is in compliance with various governmental agencies and national
safety regulations. All system ports meet the Safety Extra Low Voltage (SELV) circuits
for connection to customer-owned devices and networks. Additions of customer-owned
or third-party accessories that are attached to the machine must meet or exceed the
requirements previously listed. All modules that require external connection must be
installed per the installation procedure.
Product safety certification
This product is certified by the following Agency using the Safety standards listed below.
StandardAgency
CSA International
CAN/CSA-C22.2 No. 60950-1-07, UL 60950-1,
Second Edition
IEC60950-1, Second EditionNEMKO
Certifications in Europe
The CE marking that is applied to this product symbolize the Xerox declaration of
conformity with the following applicable Directives of the European Union as of the
dates indicated:
December 12, 2006: Council Directive 2006/95/EC as amended. Approximation of the
laws of the member states related to low voltage equipment.
December 15, 2004: Council Directive 2004/108/EC as amended. Approximation of the
laws of the member states related to electromagnetic compatibility.
March 9,1999: Radio & Telecommunications Terminal Equipment Directive 1999/5/EC
A full declaration of conformity, defining the relevant directives and referenced standards,
can be obtained from your Authorized local dealer.
Warning
• Changes or modifications to this equipment not specifically approved by the Xerox
Corporation may void the user’s authority to operate this equipment.
1-3Xerox® D95/D110/D125/D136
Safety Guide
Notices and certifications
• In order to allow this equipment to operate in proximity to Industrial, Scientific, and
Medical (ISM) equipment, the external radiation from the ISM equipment may have
limited or special mitigation measures taken.
• This is a Class A product in a domestic environment. This product may cause radio
frequency interference in which case the user may be required to take adequate
measures.
• Shielded cables must be used with this equipment to maintain compliance with
Council Directive 2004/108/EC.
Compliance with EU harmonics standard EN 61000-3-12:2005
“Equipment complying with EN 61000-3-12:2005”
This equipment complies with EN61000-3-12:2005 which defines limits for harmonic
currents which may be produced by equipment installed in the European Union and the
European Economic Area.
Compliance is based on application of limits which justify installation and unconditional
connection to the public low voltage supply.
Compliance with EU flicker standard EN 61000-3-11:2000
“Equipment complying with EN 61000-3-11:2000”
This equipment is suitable for use only in premises having a service current capacity
equal to or greater than 100 Amps per phase.
Xerox® D95/D110/D125/D1361-4
Safety Guide
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.