Xerox 6180-DN, 6180-N User Manual

Date: March 8, 2007

Subject: Volatility statement for Phaser 6180 color printer The Phaser 6180 printer does not retain any latent user image in the mechanical system of the

printer during normal operation. If a print job is disrupted prior to completion, a latent image may exist in the mechanical system of the printer. The image may be removed by clearing a paper jam (resulting from the disruption) and cycling the power or printing a new page.

No user image data is maintained in the print controller or associated RAM following the cycling of the power.

The Phaser 6180 printer contains non-volatile flash memory on the controller board. This memory is used to retain firmware and fonts. No user image data is retained in this memory.

The Phaser 6180 printer contains EEPROM memory on the controller board. This memory is used to store printer configuration, operational parameters and job history (time, document name & user name). No user image data is retained in this memory.

The Phaser 6180 printer does not support a hard disk drive The Phaser 6180 printer does not contain non-volatile memory in the form of a configuration

card. The following table lists the corresponding memory types for the Xerox Phaser 6180 printers.

Please note there are no remnants of customer image data retained in the printer when the power is cycled.

Model Number Memory Type Volatility User Data 6180/N SDRAM Volatile Yes Flash / ROM Non-Volatile No2

6180/DN SDRAM Volatile Yes1 Flash / ROM Non-Volatile No EEPROM Non-Volatile No

Notes:

SDRAM memory can be upgraded to 1152MB for all mo del s

Is used to store firmware code and fonts. No user image data is stored.

Is used to store printer configuration, operation parameters & job history (time, document name, user name). No

user image data is stored.

EEPROM Non-Volatile No

2 3

Xerox Corporation Office Printing Business, MS 7060-630 26600 SW Parkway Avenue Wilsonville, OR 97070