Wolf Ventilation Hood User Manual
INSTALLATION GUIDE
Cooktop Chimney Ventilation Hoods
Contents
Important Note
Wolf Cooktop Chimney Ventilation Hoods . . . . . . . . . . 3
Cooktop Chimney Hood Specifications . . . . . . . . . . . . 4
Cooktop Chimney Hood Installation . . . . . . . . . . . . . 10
Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Features and specifications are subject to change at any time
without notice. Visit wolfappliance.com/specs for the most
up-to-date information.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
o ensure the safe and efficient use of Wolf equipment,
T
please take note of the following types of highlighted
information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION signals a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
Wolf Cooktop Chimney Ventilation Hoods 3
wolfappliance.com/specs
Cooktop Chimney Hood Installation
IMPORTANT NOTE: T
his installation must be completed
by a qualified installer or Wolf factory certified service.
Read this entire installation guide prior to installation and
save for the local inspector’s reference. The homeowner
should keep this installation guide for future reference.
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency and amperage ratings are listed on the
product rating plate.
Record the model and serial numbers before installing the
ventilation hood. Both numbers are listed on the product
rating plate, located inside the left wall of the hood shell,
above the filter. The filter must be removed to access the
rating plate. Refer to the illustration below.
IMPORTANT NOTE: W
olf cooktop chimney hoods are
recommended for use with Wolf induction, electric and
gas cooktops and integrated modules. For ranges and
rangetops, a Wolf pro ventilation hood is recommended.
olf Cooktop Chimney Hood
W
Model Number
Serial Number
RATING PLATE
Location of rating plate.
(inside hood).
Cooktop Chimney Hood Specifications 4
67/8"
(175)
301/2" (
775)
TO
4
8
1
/2" (1232)
191/8" (
486)
3
0"
(762)
41/2" (114)
min
1
8"
(
457)
1
2"
(305)
2
1"
(533)
19/16"
(40)
6"
(152)
18" (457) 12"
(305)
191/8" (486)
3211/16" (830)
TO
507/8" (1292)
357/16" (900)
811/16"
(221)
45/16" (110)
min
21" (533)
91/4"
(235)
19/16"
(40)
339/16" (853)
TO
471/16" (1195)
42" (1067)
27" (686)
195/16" (491)
5" (127)
min
91/4"
(235)
19/16"
(40)
18" (457) 12"
(305)
12"
(305)
Overall Dimensions
30" (762) WALL HOOD
36" (914) WALL HOOD
42" (1067) ISLAND HOOD
Cooktop Chimney Hood Specifications 5
B
A C
D
MINIMUM
FLUE
EXTENSION
wolfappliance.com/specs
Hood Placement
Wolf cooktop chimney wall and island hoods come with a
telescopic chimney flue that allows you to reach a ceiling
height of 8'
extension to accommodate 10'
(2.4 m) to 9' (2.7 m) with a finished look. A flue
(3 m) ceilings is available
through your authorized Wolf dealer. For local dealer information, visit the find a showroom section of our website,
wolfappliance.com.
Installation of the cooktop chimney hood should be
24"
(610) to 30" (762) from the bottom of the hood to the
countertop. To determine placement of the hood, you
must calculate the height of the telescopic chimney flue.
The minimum and maximum flue extension for each
cooktop chimney hood is listed in the chart.
Both sections of the telescopic chimney flue must be
installed in order for the chimney to be lifted for service.
IMPORTANT NOTE: 8' (2.4 m) ceilings may not permit
installation of the wall or island hood at 30"
(762) above the
countertop.
CALCULATE CHIMNEY FLUE HEIGHT
A) Height from finished floor to finished ceiling. 8' (2.4 m)
or 9' (2.7 m) ceilings are typical.
Cooktop Chimney Hoods
FLUE EXTENSION MINIMUM MAXIMUM
CTWH30 301/2" (775) 481/2" (1232)
CTWH36 325/8" (829) 507/8" (1292)
IH4227 331/2" (851) 47" (1194)
B) Height from finished floor to countertop. A 36"
countertop height is standard.
C) Hood mounting height (bottom of hood to countertop).
Dimension C must be between 24"
8'
(2.4 m) ceilings may not allow the maximum 30" (762)
(610) and 30" (762).
hood mounting height.
D) Calculate chimney flue height: D = A – (B + C).
Dimension D must be between the minimum and
maximum flue extension listed in the chart. Refer to the
illustration.
(914)
Hood placement.
Cooktop Chimney Hood Specifications 6
Before You Start
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Wolf warranty. Refer to the cooktop
chimney ventilation hoods use & care information for
warranty details, or visit the contact & support section
of our website, wolfappliance.com.
• Make sure you have the tools and materials necessary
for proper installation.
• Any required service must be performed by a Wolf
authorized service center. Wolf is not responsible for
service required to correct a faulty installation.
• Wolf cooktop chimney hoods are shipped without the
blower assembly. Internal, in-line and remote blowers
are available through your authorized Wolf dealer.
Installation Considerations
olf cooktop chimney hoods are recommended for
W
use with Wolf induction, electric and gas cooktops and
integrated modules.
Cooktop chimney wall and island hoods are shipped
without the blower assembly. Internal, in-line and remote
blowers are available through your authorized Wolf dealer.
For local dealer information, visit the find a showroom
section of our website, wolfappliance.com.
The blower will vary in size and is dictated by the cooking
unit, the volume of air that needs to be moved and the
length of the duct run. Refer to ventilation recommendations in the Wolf design guide. These hoods have an
8"
(203) round duct with vertical discharge.
IMPORTANT NOTE: Use only a Wolf blower with the
cooktop chimney hood.
BACKSPLASH
Optional stainless steel backsplashes are available in
widths to match cooktop chimney wall hoods through
your authorized Wolf dealer. For local dealer information,
visit the find a showroom section of our website,
wolfappliance.com.
Loading...