Wolf 826102 Installation

Downdraft Recirculation Kit Installation

wolfappliance.com 800.222.7820

CONTENTS

1 Housing, recirculation

1 Filter, charcoal

1 Cover, kickplate

4 Screw,

2 Screw, 5⁄16

1 Damper

5

⁄8

INSTALLATION

1 Cut a 7" diameter hole in the base of the cabinet.

The center line for the hole must be 8

1

⁄4" from the back

of the countertop cutout. Refer to the illustration below.

2 Measure the distance from the toe kick to the front

edge of the hole (dimension "A"). See illustration below.

3 Use the "A" dimension to properly position the front

edge of the hole on the adapter plate then install using
the existing screws. The recirculation housing holes are
slotted and the adapter plate can be rotated 180°
for maximum adjustment.

4 Remove a 27

3

⁄4" x 313⁄16" section of the cabinet toekick.

See illustration below.

5 Insert the recirculation housing into the opening then

install the damper. Measure, cut and install the
appropriate length of duct to connect the damper to the
discharge of the downdraft blower. Duct is not included.

273⁄4"

Toe kick cut-out

6 Secure the recirculation housing to the cabinet toekick

313⁄16"

Install damper

using the four screws provided.

TOP VIEW

Cabinet hole cut-out

81⁄4"

A"

Position adapter plate

A"

7 Place the lter on the front of the recirculation housing

then install the kickplate cover using the two screws
provided.

Secure recirculation housing

Install lter and toekick

9004175 REV-A 02/2015

page 1 of 1