Wolf 826012, 826011, 821352, 826544 Installation

Warming Drawer Handle Installation

wolfappliance.com 800.222.7820

TUBULAR HANDLE

1 Determine the overall length of the handle. Use the

chart and illustration to determine the appropriate hole locations. Mark and drill four ¼" holes. Using a smaller bit to drill pilot holes will help ensure a proper fit.

2 Counter bore holes so the bolt heads and washers are

completely recessed. Select the appropriate length

bolts so 1

⁄8" to 1¾" of thread is exposed. Additional bolts have been included to account for different panel thicknesses. Refer to the panel preparation illustration.

3 Insert bolts with washers through the pre-drilled holes

in the panel then into the handle standoffs. Tighten bolts to secure the handle to the panel.

PRO HANDLE — 20" (508)

1 Use the chart and illustration to determine the

appropriate hole locations. Mark and drill two ¼" holes. Using a smaller bit to drill pilot holes will help ensure a proper fit.

2 Counter bore holes so the bolt heads and washers are

completely recessed. Select the appropriate length bolts so ½" of thread is exposed. Additional bolts have been included to account for different panel thicknesses. Refer to the panel preparation illustration.

PRO HANDLE — 267⁄8" (683) & 201⁄8" (511)

Use the chart and illustration to determine the

appropriate hole locations. Mark and drill two ¼" holes. Using a smaller bit to drill pilot holes will help ensure a proper fit.

2 Counter bore holes so the bolt heads and washers are

completely recessed. Select the appropriate length

bolts so 1

⁄8" to 15⁄8" of thread is exposed. Additional bolts have been included to account for different panel thicknesses. Refer to the panel preparation illustration.

3 Loosely place standoffs on the handle. Insert bolts with

washers through the pre-drilled holes in the panel then into the handle standoffs. Tighten bolts to secure the handle to the panel.

HOLE LOCATION

TUBULAR HANDLE A B C

201/8" (511) 165/16" (414) 179/16" (446) 11/4"–15/8" (32–38) 233/4" (603) 155/16" (389) 195/16" (491) 13/8"–13/4" (35–44) 267/8" (683) 241/8" (613) 253/8" (645) 13/8"–13/4" (35–44) 293/8" (746) 253/8" (645) 265/8" (676) 13/8"–13/4" (35–44)

PRO HANDLE B C

20" (508) 183/4" (476) 231/4" (591) 2113/16" (554) 11/2"–13/4" (38–44) 267/8" (683) 253/8" (645) 13/8"–13/4" (35–44)

/2" (13)

3 Insert bolts with washers through the pre-drilled holes

in the panel then into the mounting stud. Tighten bolts to secure the handle to the stud.

4 Place handle on mounting studs and secure bottom

set screws with a

⁄32" Allen wrench.

Hole location.

BOLT

SIDE VIEW

PANEL

WASHER

COUNTER

BORE

Panel preparation.

9003436 REV-A 11/2014

page 1 of 1