Wolf 824641, 824640 Installation
M Series Microwave Trim Installation
wolfappliance.com 800.222.7820
CONVECTION MICROWAVE CONTENTS
1 Assembly, frame
1 Trim, door (stainless steel models only)
12 Screw
4 Stud, ball
4 Insert, threaded
3 Assembly, duct (bottom, rear and top)
1 Template
STANDARD MICROWAVE CONTENTS
1 Assembly, frame
1 Trim, door (stainless steel models only)
2 Screw
4 Stud, ball
4 Insert, threaded
1 Assembly, duct (bottom)
1 Template
DUCT INSTALLATION (CONVECTION ONLY)
For standard microwaves skip to step 4.
3 Position the three remaining duct pieces on top of the
microwave to create the top duct assembly. Secure
each piece with two screws (one per side). Insert one
screw in the top section. Refer to the illustration below.
TOP DUCT ASSEMBLY
Attach top duct assembly.
1 Insert the horizontal duct piece into the vertical piece to
create the rear duct assembly. Secure with one screw.
Refer to the illustration below.
2 Remove the existing screws from the upper right and left
rear of the microwave. Position the rear duct assembly
on the microwave and re-insert screws as shown in the
illustration below.
EXISTING
HORIZONTAL
VERTICAL
DUCT
DUCT
Assemble rear duct.
SCREW
Attach rear duct assembly.
REAR DUCT
ASSEMBLY
EXISTING
SCREW
9002491 REV-C 01/2016
page 1 of 2
M Series Microwave Trim Installation
wolfappliance.com 800.222.7820
4 Install the bottom duct assembly. The duct must be
recessed back from the front edge of the opening and
offset to the right or left depending on the trim being
installed. The 'LEFT' and 'RIGHT' dimensions are from
the center line of the opening. Refer to the chart below.
Pre drill pilot holes and secure the duct using two screws.
DUCT ASSEMBLY OFFSET
CONVECTION RECESS LEFT RIGHT
Stainless Trim
Black Trim
STANDARD RECESS LEFT RIGHT
Stainless Trim
Black Trim
5 Place the microwave as close to the cabinet opening
3
3
1
1
9
⁄4"
⁄16" -
⁄4" -
⁄8" 1" -
⁄8" -
3
⁄8"
3
⁄8"
as possible and plug the power cord into a properly
grounded electrical outlet.
6 Guide the microwave into the opening and push back.
Align the feet on the microwave with the bottom duct.
7 Align the template with the opening and pre-drill
four 3/16" holes, then install threaded inserts.
Verify the insert is aligned with the cabinet face.
Do not to overtighten.
8 Install the ball studs into the threaded inserts but do not
overtighten. Align the frame assembly with the opening
and press rmly to engage the ball studs.
9 For stainless steel models only, attach the door trim
provided by removing the paper backing from the tape
and aligning the bent ange with the left side of the door.
Press rmly to apply.
RECESSRECESS
TEMPLATE
RECESSRECESS
FRAME ASSEMBLY
RECESSRECESS
Install bottom duct.
Install microwave.
(Convection microwave shown)
Align template.
Attach assembly.
page 2 of 2
Loading...