Wolf 824490 Installation

Gas Cooktop High Altitude Conversion Installation
wolfappliance.com 800.222.7820
CONTENTS
1 Orice, 18,000/20,000 Btu burner, ‘166’
2 Screw, #8–32 x 11/2"
1 Label, high altitude conversion
This conversion kit shall be installed by a qualied service agency in accordance with the manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not followed exactly, a re, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualied service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specied in the manufacturer's instructions supplied with the kit.
This kit is only valid for models with a serial number 18085871 and higher, installed above 9,900' (3018 m) in altitude.
CAUTION
Before proceeding with the conversion, shut off the gas supply to the appliance prior to disconnecting the electrical power.
SURFACE BURNERS
1 Remove the burner cap, then extract two screws from
the 18,000/20,000 (5.3kW/5.9kW) surface burner. Do not attempt to remove the two tamper proof screws from the burner.
2 Gently lift the burner, then disconnect the igniter wire.
Set burner assembly aside.
3 Extract the existing main orice from the burner and replace
with a new ‘166’ orice. Refer to the illustration below.
4 Once the orice has been installed, reinstall the igniter
wire and two screws. Verify the burner is seated properly, then tighten screws to 24 in-lb.
SIMMER ORIFICE
BURNER
CAP
Surface burner.
SCREWS
MAIN ORIFICE
Surface burner orice.
824989 REV-B 09/2016
page 1 of 1
Loading...