How it Works
Windmere
Loading...
HA-3206
User Manual
7 pgs212.28 Kb0

Windmere HA-3206, BD20P User Manual

2-SPEED BLENDER(Pages 1-5)
LICUADORA DE 2 VELOCIDADES (Páginas 6-10)
SAVE THIS USE AND CARE BOOK
CONSERVE ESTE INSTRUCTIVO
MODELS/MODELOS BD20P, HA-3206
HOUSEHOLD USE ONLY
PARA USO DOMESTICO SOLAMENTE
2
1
When using electrical appliances, basic safety precautions should be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING.
■ To protect against risk of electrical shock, do not put motor end of the appliance in
water or other liquid.
■ This appliance should not be used by children, and care should be taken when used
near children.
■ Unplug from outlet when not in use, before putting on or taking off parts, and before
cleaning.
■ Avoid contacting moving parts.
■ Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions or is dropped or damaged in any manner. Return appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.
■ Do not use on stove.
■ The use of attachments, including canning jars, not recommended by the
manufacturer may cause a risk of injury to persons.
■ Do not use outdoors.
■ Keep hands and utensils out of container while blending to reduce the risk of severe
injury to persons or damage to the blender. A scraper may be used but must be used only when the blender is not running.
■ Blades are sharp. Handle carefully.
■ To reduce the risk of injury, never place cutter-assembly blades on base without
container properly attached.
■ Always operate blender with cover in place.
■ When blending hot liquids, remove center piece of two-piece cover.
OPERATING INSTRUCTIONS
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
PRODUCT DIAGRAM
Cap
Lid
Container
Cutting Blade Assembly
Base
P/OFF/1/2 (Pulse/Off/Low/High Switch)
Container
Cap
Lid
Cutting Blade Assembly
Rubber Gasket
Collar
P/OFF/1/2 (Pulse/Off/Low/High Switch)
ASSEMBLY DIAGRAM
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS
LINE CORD SAFETY TIPS
1. Never pull or yank on cord or the appliance.
2. To insert plug, grasp it firmly and guide it into outlet.
3. To disconnect appliance, grasp plug and remove it from outlet.
4. Before each use, inspect the line cord for cuts and/or abrasion marks. If any are found, this indicates that the appliance should be serviced and the line cord replaced. Please return it to our Service Department or to an authorized service representative.
5. Never wrap the cord tightly around the appliance, as this could place undue stress on the cord where it enters the appliance and cause it to fray and break.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE, OR IF APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
If the supply cord is damaged, it must be replaced by the manufacturer or service agent or a similarly qualified person in order to avoid a hazard.
ELECTRIC CORD
An extension cord may be used with care; however, the marked electrical rating shall be at least as great as the electrical rating of this appliance. The extension cord should not be allowed to drape over the tabletop where it can be pulled on by children or tripped over.
4
3
This appliance is for HOUSEHOLD USE ONLY. It may be plugged into any 230-volt AC electrical outlet (ordinary household current). Do not use any other type of outlet.
INITIAL USE
When unpacking blender make sure to use caution when handling the cutting blade assembly, as it is sharp. Before using blender for the first time: Wash lid, cap, container, rubber gasket and cutting blade assembly in hot, soapy water. Wipe the blender base and inner well with a damp cloth or sponge to remove any packaging dust.
NEVER IMMERSE blender base, cord or plug, in water or other liquids. Use only gentle liquid detergents. Do not use harsh detergents or abrasive cleaners on any parts of the blender.
ASSEMBLY INSTRUCTIONS
1. Place blender on flat, level surface.
2. Make sure blender is unplugged.
3. Place rubber gasket inside cutting blade assembly. Securely screw cutting blade assembly to container by twisting it counterclockwise and place assembled unit on base. Secure cap in lid and place lid on container.
HOW TO USE BLENDER
1. Be sure switch is Off.
2. Plug blender into any 230-volt AC outlet.
3. Place ingredients into container.
4. Make sure cap is in lid and lid is secure on top of the container.
5. Turn switch to desired speed setting: Low (1), High (2) or Pulse (P). NOTE: The Maximum continuous operating time: 3 minutes.
6. Turn switch to Off when processing is finished. Before removing the lid or the container from the base, wait for cutting blade to stop. To remove the container from the base, grasp base with one hand, and use the other hand to lift container from base.
CAUTION: If container rotates during blending, immediately turn Off, then secure by tightening cutting blade assembly on container.
USING BLENDER CONTROL NOTE: Due to the varieties in amount and consistency of some foods when processed,
the following should serve only as guidelines for processing.
Use Low speed (1) to: STIR: Frozen juices, whole eggs, instant puddings, gelatins
BEAT: Thin batters and sauces PUREE: Cooked fruits and vegetables for baby foods, special diet foods CREAM: Smooth spreads and dips CHOP: Fresh fruits, vegetables, nuts, pickles, hard-boiled eggs MIX: Batters, fillings, sauces, dips and gravies WHIP: Mixed drinks, whipped cream Use High speed (2) to:
MINCE: Onions, garlic, vegetables, nuts GRATE: Coconut, citrus peel, whole spices
SHRED: Coarsely chopped vegetables BLEND: Nut batters, hollandaise sauce and salad dressing GRIND: Coffee, split peas, bread and nuts FRAPPÉ: Malts, milk shakes, fitness drinks and smoothies LIQUEFY: Fruits and vegetables in liquid, desserts
Use Pulse blending (P) for small quantities or short blending cycles and for crushing ice. For pulse blending, move switch toward Pulse setting and quickly release it for short bursts of power.
CRUSHING ICE: Add liquid first. Then add ice cubes one at a time. This blender is not capable of the following functions: Grinding meat, mashing boiled
potatoes, kneading dough, whipping egg whites stiff, extracting juice from vegetables and fruits.
HOW TO USE
CARE AND CLEANING
This appliance requires little maintenance. It contains no user serviceable parts. Do not try to repair it yourself. Refer it to qualified personnel if servicing is needed.
• Always unplug the unit before cleaning.
• Remove lid from container and separate cap from lid by twisting cap counterclockwise and pulling upward.
• To clean the container, disassemble the blender by lifting container from base and cautiously unscrewing cutting blade assembly and removing it from container.
• Separate rubber gasket from cutting blade assembly.
• Wash lid, cap, container, gasket, and blade assembly in hot, soapy water. Rinse and dry thoroughly.
• Wipe outside surface and inner well of base with a damp cloth or sponge.
REMINDER: NEVER IMMERSE base in water or any other liquids.
• Reassemble (see ASSEMBLY INSTRUCTIONS).
• When storing blender, leave lid slightly open to prevent container odor.
NOTE: The container, including the cutting blade assembly, lid and cap, must be washed only by hand. Do not put these parts in an automatic dishwasher, as damage may occur due to heat and water pressure.
Loading...
+ 4 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use