Whirlpool WED8620HC, YWED8620HC, WGD8620HC, WED8620HW, YWED8620HW Dimension Guide

White

Available

YWED8620HW - Electric

WED8620HW - Electric

WGD8620HW - Gas

Dimension Guide

Whirlpool® Dryer with

Steam Cycles - 7.4 cu ft

Chrome Shadow

Available

YWED8620HC - Electric

WED8620HC - Electric

WGD8620HC - Gas

W11462158B

DETAILED PLANNING DIMENSIONS

WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance's Owner's Manual, before installing and operating this appliance.

Electrical Requirements

Fuel Type

Electric

Gas

Minimum Circuit

30 A

15 A

Amperage Rating

Maximum Amperage Draw

24 A

6 A

Operating Voltage

240 V AC only

120 V AC only

230 V AC only (Canada)

Operating Frequency

60 Hz

A

		D
	B	E
		C
		Product Dimensions

		in (Minimum)	in (Maximum)	mm (Minimum)	mm (Maximum)
A	Height (with feet)	381∕8	39	968	989
B	Width	27	-	686	-
C	Depth	31	-	787	-
D	Side Vent Height (feet min)	31∕2	43∕8	89	111
E	Side Vent (from back)	103∕16	-	258	-

2

DETAILED PLANNING DIMENSIONS

	F
	90°
	613.24
	(24.1)
	G
	H
M	O
	P
	N

I

J

K

L

Product Dimensions

		in (Minimum)	in (Maximum)	mm (Minimum)	mm (Maximum)
F	Depth with Door Open	545∕16	-	1378	-
G	Strain Relief from Side (elec)	63∕8	-	163	-
H	Strain Relief Height (elec)	297∕8	3011∕16	759	780
G	Power Cord from Side (Canadian)	63∕8	-	163	-
H	Power Cord Height (Canadian)	297∕8	3011∕16	759	780
	Power Cord Length (Canadian)	533∕8	-	1356	-
I	Power Cord from Side (gas)	313∕16	-	96	-
J	Power Cord Height (gas)	3113∕16	3211∕16	808	829
	Power Cord Length (gas)	72	-	1828	-
K	Gas Valve Height	55∕8	66∕16	142	163
L	Gas Valve from Side	13∕8	-	36	-
M	Exhaust Duct Height	31∕2	43∕8	90	111
N	Exhaust Duct from Side	141∕8	-	358	-
O	Water Inlet Height	35∕8	43∕8	91	112
P	Water Inlet from Side	61∕8	-	156	-

3

DETAILED PLANNING DIMENSIONS

Spacing for recessed area or closet installation

The dimensions shown are for the recommended spacing allowed.

ɃAdditional spacing should be considered for ease of installation and servicing.

ɃAdditional clearances might be required for wall, door, and floor moldings.

ɃAdditional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.

ɃFor closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilations openings are acceptable.

ɃCompanion appliance spacing should also be considered.

14" maximum (356 mm)

3" (76 mm) 48 in2

(310 cm )

18" (460 mm)

24"2/in24"2 3" (155 cm )

(76 mm)

6"/0"*
(152 mm/0 mm)	1"

(25 mm)

1"/0"*

(25 mm/0 mm)

*Recommended/Minimum spacing

4