WHIRLPOOL TDLRB 6242BS EU/N Daily Reference Guide
Quick guide
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.whirlpool.eu/register
CONTROL PANEL
1 Programme selector
2 “Start/Pause“ button
3 “Reset/Drain“ button
4 “Temperature“ button
5 “Start delay“ button
6 Child lock combination
7 “Spin“ button
8 Time
9 Temperature
10 Washing phase
PROGRAMME CHART
Before using the appliance carefully read the Safety Instruction.
Before using the machine, it is imperative that the transport bracket is removed.
For more detailed instructions on how to remove it, see the Installation Guide.
INDICATORS
10 89
Detergent over dosage
Door open
Failure: Service
Failure: Clean pump
Failure: Water tap closed
In the event of any failure, refer to the
7
“TROUBLESHOOTING“ section
1 2 3 4 5 6
EN
Max load 6,0 Kg
Power consumption in o-mode 0,11 W / in left-on mode 0,11 W
Temperatures
Programme
Setting Range
Max.
Spin
speed
(rpm)
Max
load
(kg)
Dura-
tion (h
: m)
Rapid 30’ 30°C 20 - 30°C 1200 3,0 0:30
1151 6,0 3:15 –
40°C 40°C
1151 3,0 2:35 –
1151 1,5 1:55 –
Aqua saver 40°C 20 - 40°C 1200 2,5 ** –
Colours 40°C 20 - 60°C 1000 4,0 **
Jeans 40°C 20 - 60°C 1000 4,0 **
Hygiene 60°C 60°C 1200 6,0 ** –
20°C 20°C 1200 6,0 3:15 –
Rinse & Spin – – 1200 6,0 ** – –
Spin – – 1200 6,0 ** – – – – – – – – –
Wool 40°C 20 - 40°C 1000 1,0 ** –
Delicates 40°C 20 - 40°C 1000 1,5 **
Synthetics 40°C 20 - 60°C 1200 3,0 2:15
Cotton 60°C 20 - 95°C 1200 6,0 2:30
Mixed 40°C 20 - 60°C 1200 3,0 ** –
6,0 4:00 –
3,0 2:30 –
Eco cotton 60°C
60°C 1200
40°C 1200 3,0 2:30 –
Dosing required Dosing optional
Eco cotton - Test wash cycles in compliance with regulations 1061/2010. Set wash cycle at
a temperature of 40°C or 60°C to access this cycles.
Eco 40-60 - Test wash cycle in compliance with 2019/2014 regulation. The most ecient
programme in terms of energy and water consumption for washing normally soiled cotton
laundry. Display only: Spin speed values shown on the display can slightly diers from the
values stated in the table
For all Test I nstitutes
Long wash cycle for cottons: set wash cycle Cotton with a temperature of 40°C.
Synthetic program along: set wash cycle Synthetics with a temperature of 40°C.
Detergents and additives
Prewash
Main
wash
Softener
This data may dier in your home due to changing conditions in inlet water temperature,
water pressure etc. Approximate programme duration values refer to the default setting of
the programmes, without options. The values given for programmes other than the eco 4060 programme are indicative only.
* After programme end and spinning with maximum selectable spin speed, in default
programme setting.
** The duration of the programme is shown on the display.
6th Sense - The sensor technology adapts water, energy and programme duration to your
wash load.
Recommended
Powder Liquid
– –
detergent
Residual
dampness % *
–
57 0,25 42 27
Total water lt
consumption
kWh
Energy
53 0,78 52 40
53 0,41 40 32
53 0,31 30 30
– – – –
– – – –
–
– – – –
– – – –
–
53 0,25 46 20
– – – – – –
–
–
– – – –
– – – –
40 0,56 50 40
55 1,02 48 55
– – – –
44 0,62 46 -44 0,55 32 -44 0,44 32 --
Laundry
temperature °C
PRODUCT DESCRIPTION
1. Lid handle
2. Lid
3. Control panel
4. Detergent dispenser
5. Drum
6. Water lter - behind the cover
7. Mobility lever (depending on model)
8. Adjustable feet (x2)
DETERGENT DISPENSER
1.
Main wash compartment
Detergent for the main wash, stain remover or
3.
2.
water softener.
4.
Prewash compartment
Detergent for the prewash.
5.
Softener compartment
Fabric softener. Liquid starch. Bleach.
Pour in softener, starch or bleach solution only
up to the “max” mark.
Release button
Press to remove tray for cleaning.
6.
7.
8.
PROGRAMMES
For choosing the appropriate programme for your kind of
laundry, always respect the instructions on the care labels of
the laundry. The value given in the tub symbol is the maximum
temperature possible for washing the garment.
Rapid 30’
For washing lightly soiled garments quickly. This cycle lasts only 30 minutes,
saving time and energy.
Eco 40-60
For washing normally soiled cotton garments declared to be washable at 40
°C or 60 °C, together in the same cycle. This is the standard cotton programme
and the most efficient in terms of water and energy consumption.
Aqua saver
Lightly soiled laundry made of synthetic fifibres, or synthetics mixed with
cotton garments. Saving programme with a very low water consumption. Use
liquid detergent and the lowest recommended amount for 2.5kg laundry. Do
not use softener.
Colours
White and pastel shaded garments made of delicate fabrics.
Gentle wash programme to avoid graying or yellowing of your laundry. Use
heavy duty detergent, if necessary also stain removers or bleaches on oxygen
basis. Do not use liquid detergent.
Jeans
Turn garments inside-out before washing and use a liquid detergent.
Hygiene
This program removes 99 % of bacteria while washing normally to heavily
soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton
and linen.
20 °C
For washing lightly soiled cotton garments, at a temperature of 20 °C.
Rinse & Spin
Separate rinse and intensive spin programme. For robust
laundry.
Spin
Spins the load then empties the water. For robust laundry.
Wool
All wool garments can be washed using programme ‚ “Wool“ even those
carrying the “hand-wash only“ label. For best results, use special detergents
and do not exceed max kg declaration of laundry.
Delicates
For washing particularly delicate garments. Preferably turn garments inside
out before washing.
Synthetics
For washing soiled garments made from synthetic fibres (such as polyester,
polyacrylic, viscose, etc.) or cotton/synthetic blends.
Cotton
Normally to heavily soiled and robust cottons .
Mixed
For washing lightly to normally soiled resilient garments in cotton, linen,
synthetic fibres and mixed fibres.
Eco cotton
For washing normally soiled cotton garments. At 40°C and 60°C
FIRST TIME USE
To remove any manufacturing debris select the “Cotton“ programme at
a temperature of 95°C. Pour a small quantity of detergent powder into the
main wash compartment of the detergent dispenser (maximum 1/3 of the
quantity the detergent manufacturer recommends for lightly soiled laundry).
Start the programme without adding any laundry.
DAILY USE
Prepare your laundry according to the recommendations in the “HINTS
AND TIPS“ section. Load the laundry, close the drum door and check that
it is closed properly. Pour in the detergent and any additives. Observe the
dosing recommendations on the detergent pack. Close the lid. Turn the
programme selector to the desired programme and select any option if
needed. The display shows the duration of the selected programme (in hours
and minutes), and the indicator for the “Start/Pause“ button flashes. The
temperature and spin speed can be changed by pressing the “Temperature“
button or the “Spin“ button. Open the tap and press the “Start/Pause“
button to start the wash cycle. The “Start/Pause“ indicator will lights up
and the door will be locked. Due to variations in load and temperature of inlet
water, the remaining time is newly calculated in certain programme phases. If
this is the case, an
animation appears on the time display.
PAUSE OR CHANGE A RUNNING PROGRAMME
To pause the wash cycle, press the “Start/Pause“ button, the indicator light
blinks. Select any new programme, temperature, options or spin speed if you
wish to change those settings. Press the “Start/Pause“ button again to
start the wash cycle from the point at which it was interrupted. Do not add
detergent for this programme.
DOOR OPEN INDICATOR
Before starting and after the end of a programme, the “Door open“
indicator lights to show that the lid can be opened. As long as a wash
programme is running, the lid remains locked and must on no account be
forced open. In case you have an urgent need to open it during a running
programme, for example to add more laundry, or to remove laundry
which was loaded by mistake, press the “Start/Pause“ button. If the
temperature is not too high, the “Door open“ indicator light turns on.
It may last a while until you can open the lid. Press “Start/Pause“ to
proceed with the programme again.
PROGRAMME END
The “Door open“ indicator lights up and the display shows . Turn the
programme selector to the “O“ position and close the water tap. Open the
lid and drum and unload the machine. Leave the Lid open for some time to
allow the interior of the machine to dry. After about a quarter of an hour,
the washing machine will switch off completely to save energy.
To cancel a running programme before the end of cycle, press the
“Reset/Drain“ button for at least 3 seconds. The water is drained out. It
may last a while until you can open the lid.
OPTIONS
! When the combination of programme and additional option(s) is not
possible, the indication lights switch o automatically.
! Unsuitable combinations of options are deselected automatically.
Colours 15°
Saves energy used for water heating while maintaining a good wash
result. Supports colour maintenance when washing coloured laundry.
Recommendable for lightly soiled laundry without stains. Make sure that your
detergent is suitable for cold wash temperatures.
FreshCare
Select this option if you cannot unload the laundry soon after programme
end, or if you tend to forget the laundry in your washing machine. It will
help to keep your laundry fresh. The washing machine will start to tumble
the laundry periodically after programme end. The light of the “Fresh care“
button will blink while this function is active, and the display will show an
animation. The periodic tumbling will last up to approximately 6 hours after
the end of your wash programme, and you can stop it at any time by pressing
the “Fresh care“ button. It will last a while until you can open the door. After
the “Fresh care“ period has run out, the display indicates .
Temperature
Every programme has a predefined temperature. If you want to change the
temperature, press the “Temperature“ button. The value appears on the
display.
Start delay
To set the selected programme to start at a later time, press the “Start delay“
button to set the desired delay time. The lamp for the
“Start delay“ option button lights up, and it goes off when the programme
starts. Once having pressed the “Start/Pause“ button, the countdown
of the time delay begins. Number of hours pre-selected can be reduced by
pressing the “Start delay“ button again. Do not use liquid detergent
when activating this option. To cancel the “Start delay“ turn the
programme selector to another position.
Rapid
Enables quicker washing by shortening the programme duration.
Recommendable for small loads or only lightly soiled laundry.
Prewash
Only for heavily soiled loads (for example sand, granular dirt). Increases the
cycle time by approximately 15 min. Do not use liquid detergent for the main
wash when activating the Prewash option.
Intensive rinse
Helps to avoid detergent residues in the laundry by extending the rinse
phase. Particularly suitable for washing baby laundry, for people suffering
from allergies and for areas with soft water.
Spin
Every programme has a predefined spin speed. If you want to change the
spin speed, press the “Spin“ button. If spin speed “0“ is selected, the final
spinning is cancelled but intermediate spin peaks remain during the rinse.
The water is drained out only.
Loading...