Whirlpool sb100pes3 Installation Instruction

I

I

Before you start...

Check locahon where wall oven

ALL OPENINGS IN THE WALL

will be installed The location

OR FLOOR WHERE THE

Proper Installation is your responsibility

should be away from strong draft

WALL OVEN IS TO BE INSTALLED

Make sure YOU have evervihlna necessarY

areas, such as windows. doors.

MUST BE SEALED.

FOR YOUR SAFETY

If you smell gas:

1. Open windows.

2. Don’t touch electrical switches

3. Extinguish any open flame.

4. Immediately call your gas
supplier.

for correct /nstallation It ii the &sponsibili$

and strong heating vents of fans.

of the installer to comply with the installation

The wall oven should be

clearance specified on the serial/rating

located for convenient use

Note: Clearances specified

plate. The serial/rating plate can be in the kitchen.

are for combustible walls and

? oven frame behind the

materlals that have a density Of

found on tht

lower oven (

( Given dimensions provide 0”

clearance Dlmenslons aiven

clearances has been
made for installations

are for wall oven sitting On

adjacent to materials that

cabinet floor. Cabinet floor must

are less than 20 pounds

be solid and level. per cu. ft. or to plastic tiles

and sheeting.

FOR YOUR SAFETY 1

z;EzFd (
liquids in the vlcmlty of this

Depth lo control

1 FOR YOUR SAFETY 1

Do not obstruct the flow of
combustion and ventilation air.

I FOR YOUR SAFETY I

The maximum gas suppl
pressure for this
must not exceed

Important: Observe all govemlng
coder and ordlnancesfollure t6 meet
codes and ordinances could lead to
tire or electrical shock hazard.

Moblle Home lnstallatlon

The installation of this wall oven must
conform to the Manufactured Home
Construction and Safely Standards. Title
24 CFR. Part 32-80 (formerly the Federal
Standard foe Mobile Home Construction
and Safety, ntle 24, HUD (pail 280)).

Copies of the standard listed above
may be obtained from:

-American

Gas Asoclatlon

1515 Wilson Boulewrd

Mlngton.Vlrglnla 22209

l

* Natlonal Fire ProtectIon Awclatlon

Botierymarch Park
Qulncy,

Massachuseftr 02269

Grounded electrical outlet: is required
See Electrical Requirements.

Proper gas supply connection must be

me

recessed lnstallatlon area must

available. See Gas Supply

provide complete enclosure around the

Requirements.

recessed portion of the oven.

Tools needed for installation.

C

This wall oven Is equipped faf

n use with NATURAL gas. It is
certified bv A.G.A. for NATURAL and L.l?
gases with appmpriate conversion. The
serial/rating plate located on the oven
frame behind the broiler door has
information on the type of gas that can
be used If this informatlon daes not
agree with the type of gas avallable.
check with the local gas suppller. See
Backcover for L.F! gas conversion
instructions. -

D

n

Provide a gas supply line of

%” rigid pipe to the wall oven
location either thrwah the wall or
cabinet floor. Keep &e near the wall.
The wall oven gas fittIne is Itied al
uaaer left side of aooliance. Pipe lolnt
compounds resistait’to the acti& bf LJ?
gas must be used. with L.F! gas, plplng 0T
tubing size can be Yz” minimum. L.F! gas
supplIers usually determine the size and
materlals used on their system.

Gas Supply
Requirements

Obsek all govemlng codes
and ordinances.

G

If rtgl

n supply line, a combination of
pipe fittings must be used to obtain an
in-line connection to the wall oven. All
strains must be removed ham the suwlv

E

If local codes permlt, A.G.A.

n certified flexible metal tubing
(new) IS recommended far connecting
this wall oven to the gas supply line. Do
Not kink or damage the flexible tubing
when moving the wall oven. A Y2N male
pipe thread is needed for ccnnectian to
pressure regulator female pipe threads.

A

n

This installation must conform
with local cc&s and

and fuel lines so wall oven will be leb&l
and in line

H

The inlet pressure to the

n regulator should be as follows
for both operation and checking
regulator setting:

NATURAL GAS:

Mlnlmum pressure 5 Inches

Maxlmum pressure 14 Inches
L.F! GAS:

Mlnlmum pressure 11 Inches
Maxlmum pressure 14 Inches

ordinances. In the absence of local
codes. installation must conform with
American National Standard, NatIonal
Fuel Gas Code ANSI 2223.14984:

-I

The wall oven and ik Individual

n shut-d valve must be
dIsconnected from the gas supply
piplng system during any pressure
testing of that system at test pressures
in excess of YZ psig (3.5 kPa].

The wall oven must be lkolated from the
gas supply piplng System by closing its

individual manual shutoff valve duting
any pressure testing of the gas supply
piping system at test pressures equal to
or less than Yz psig (3.5 kPa].

The supply line should be

equipped with a shut-off valve.
This valve should be located in the same
rmrn as the wall oven and should be in
a location that allows ease of apenlng
and closing. Do Not block access to
shukff valve.

This wall oven is equipped with an oven
burner shut-off valve located on the wall
oven manifold.

the serial/rating

plate ore

for elevations up to 2,aw) feet. For
elevations above 2.ooO feet, ratings
should be reduced al a rate of 4%

for each 1,ooO feet above sea level.

PANEL A