Whirlpool OBI B30 W, OBI B30 S, OBI C30 S, OBI C30 W INSTRUCTION FOR USE
10
CONTENTS
INSTALLATION PAGE 11
ELECTRICAL CONNECTION PAGE 12
BEFORE USING THE OVEN PAGE 13
PRECAUTIONS AND GENERAL SUGGESTIONS PAGE 13
OVEN COOKING FUNCTIONS PAGE 15
CLEANING THE OVEN AND ITS ACCESSORIES PAGE 16
TROUBLE-SHOOTING GUIDE PAGE 17
AFTER-SALES SERVICE PAGE 18
EU DECLARATION OF CONFORMITY PAGE 18
HINTS FOR PROTECTING THE ENVIRONMENT PAGE 13
OVEN ACCESSORIES PAGE 14
GB
11
INSTALLATION
Technical information for the
installer
•
Unpack the oven to make the connections.
Rest the oven on the polystyrene base to
avoid damaging it.
•
Do not lift the oven by the door handle, but
hold it at the sides.
•
Make sure that the appliance has not been
damaged during transport.
•
The dimensions of the oven and the unit are
given in the picture at the side.
•
Units in contact with the oven must be heat
resistant (90°C).
•
If plastic laminates or the sealing material
are not sufficiently heat resistant, bubbles
may form, the surface may be deformed or
the coating may detach.
•
House the oven in the unit cavity, lifting it
at the sides and making sure that the supply
cable is not trapped.
•
To ensure correct ventilation, respect the
ventilation openings indicated in the picture
(200 cm2minimum)
.
•
Fasten the oven to the unit with the screws
(A) as shown.
•
The oven can also be fitted under a
cooktop.
•
There must be a gap of at least 5 mm
between the upper edge of the oven and
the lower edge of the working surface. This
gap must never be closed by strips or unit
reinforcing pieces. When the oven is
installed, make sure that the sides do not
touch the front edges of the unit or the
adjacent drawers and door (see picture).
*
: 590 For D+CH only
*
12
ELECTRICAL CONNECTION
•
Do not switch on the oven before
connection is complete.
•
Make sure that the installation and the
electrical connection are made by a
qualified engineer according to the
manufacturer’s instructions and the local
rules in force.
•
The installer is responsible for the correct
electrical connection and for observance of
the safety rules.
•
The appliance must be connected to the
mains by means of an omnipolar switching
device with a contact opening distance of at
least 3 mm.
•
Earthing of appliances is obligatory by law.
•
Do not use multiple sockets or extensions.
•
After the installation, the electrical parts
must be inaccessible.
•
Make sure that the voltage stated on the
appliance rating plate is the same as the
voltage in your home.
The rating plate is on the front edge of the
oven (visible when the door is open).
Loading...