Whirlpool KHPF 9010/I/01, KHPS 9010/I/01 INSTRUCTION FOR USE

Instructions for use

Product description and symbols 4

Using the burners 4

Practical advice on using the hob 5

Positioning the pan supports and wok support 5

Hood and cabinetry clearances (mm) 6

Injector table 6

Warnings and suggestions 7

Safeguarding the environment 8

EC Declaration of conformity 8

Installation (Flush and Traditional fitting) 9

Gas connection 9

Electrical connection 10

Fixing the hob to the work top. Traditionally fitted model 10

Fixing the hob to the work top. Flush fitted model 11

Adaption to a different type of gas supply 12

Replacing the injectors 12

Fitting the wok burner 13

Regulating the minimum flow level of the gas taps 13

General cleaning & maintenance 14

Care and maintenance of the gas burners 14

Troubleshooting guide 15

After Sales Service 15

1. Removable pan supports

2. Auxiliary burner

3. Semi-fast burner

4. Fast burner

5. Semi-fast burner

6. Professional wok burner

7. Auxiliary burner control knob

8. Semi-fast burner control knob

9. Fast burner control knob

10. Semi-fast burner control knob

11. Professional wok burner control knob

Control Symbols

Off

Maximum flame

Minimum flame

Product description and symbols

To turn on one of the burners:

1. Turn the corresponding control knob anticlockwise until the indicator coincides with

the maximum flame symbol .

2. Press the control knob to ignite the burner.

3. Once the burner has lit, keep the control knob pressed for about 5 seconds to allow the safety thermocouple fitted to each burner to engage. The thermocouple will switch off the gas supply to the burner should the flame be accidentally lost ( A gust of air, momentary interruption of gas supply or liquid spillage etc).

If the burner does not ignite within about 15 seconds, switch off the burner, check the fitting of the burner cap and plate for correct fitting. Wait at least 1 minute before trying again.

If the burner goes out when the control knob is released, the thermocouple did not engage. wait al least 1 minute before repeating strps 1 to 3.

Sometimes, when switching on the WOK’s burner when cold, the external crown may take from 2 to 5 seconds to come on. This is a normal behaviour, due to the time taken for the gas to reach the crown itself.

Using the burners

Read the instructions to get the best out of your hob.

• Use pans with a similar diameter to the burner (see the table on this page).

• Use flat bottomed pans except with the wok support.

• Do not use excessive water when cooking foods and use the lid.

• Ensure that pans are fully supported by the pan supports and do not protrude over the edges.

You should never use:

• two burners simultaneously with just one container such as a fish kettle.

Important:

Do not rest or drag the pan supports upside down on the hob as this could scratch it.

Failure to comply with these recommendations could lead to the glass ceramic hob being damaged, or broken and the safety of your appliance being compromised.

Burner Pan diameter

wok from 24 to 26 cm fast from 24 to 26 cm semi fast from 16 to 24 cm auxiliary from 8 to 14 cm

Practical advice on using the hob

Position the pan supports and wok support as indicated in the diagram.

Positioning the pan supports and wok support

+ 11 hidden pages