Whirlpool HOB 602 S, HOB 601 S, HOB 611 B, HOB 612 AL N, HOB 601 B User Manual
...
6gb53191.fm Page 11 Wednesday, December 10, 2003 10:24 AM
INSTRUCTIONS FOR USE
BEFORE USING THE GLASS-CERAMIC HOB
INSTALLATION
ELECTRICAL CONNECTION
ENERGY SAVING TIPS
PROTECTING THE ENVIROMENT
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
COOKTOP ACCESSORIES
CARE AND MAINTENANCE OF THE
GLASS-CERAMIC COOKTOP
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
11
6gb53191.fm Page 12 Wednesday, December 10, 2003 10:24 AM
BEFORE USING THE GLASS-CERAMIC HOB
To make the most of your new appliance,
•
please read the user instructions carefully and
keep them to hand for future consultation.
INSTALLATION
Cooktop
• The cooktop must be set into a worktop between 20
mm and 50 mm deep.
• There must be nothing between the cooktop and the
oven (cross rails, brackets, etc.).
• The distance between the lower face of the glass
ceramic hob and the cupboard or separating panel
must be at least 20 mm.
• If the cooktop is to be installed next to a column unit,
leave a distance of at least 100 mm from the edge of the
cooktop.
Make an opening in the worktop of the dimensions shown in
•
the Product Description Sheet supplied separately.
Apply the supplied gasket to the cooktop (unless it has already
•
been fitted), after having cleaned its surface.
Important
In order to prevent the electronic circuits from overheating, and
therefore from being damaged, we recommend the following:
• Do not install the cooktop near the dishwasher or
washing machine, so that the electronic circuits are not
in contact with steam or moisture, which could damage
them.
If there is an oven under the hob (manufactured by us), make
sure that it is equipped with a cooling system.
If the temperature of the electronic circuits exceeds the
maximum permitted temperature, the cooktop will switch off
automatically; in this case, wait for a few minutes until the
internal temperature of the electronic circuits reaches a tolerable
level, at which point it will be possible to switch the cooktop on
again.
• Switch off the hob after use.
12
6gb53191.fm Page 13 Wednesday, December 10, 2003 10:24 AM
INSTALLATION
Assembly
A)
If the worktop is made of wood
clips and screws.
Position the 4 clips (A) as shown and at the specified
•
distance.
Secure the clips using the 4 screws (B).
•
Fit the cooktop in the prepared worktop (see figure).
•
B)
If the worktop is made of marble or other materials
(plastic compounds, ceramics, stone, etc.)
must be fitted by means of brackets code 4819 404 78697
(to be requested from the After-Sales Service).
Position the cooktop into the prepared worktop.
•
Position the 3 brackets (C) as shown in the figure, in
•
accordance with the thickness of the worktop.
Secure the three screws (E) in the holes (D).
•
, use the supplied spring
, the cooktop
13
Loading...