Whirlpool HOB 400 S, HOB 410 S, HOB 440 S INSTRUCTION FOR USE
6gb66001.fm5 Page 9 Tuesday, December 18, 2001 2:59 PM
INSTRUCTIONS FOR USE
BEFORE USING THE COOKING HOB
INSTALLATION - TECHNICAL
INFORMATION FOR THE INSTALLER
ENERGY SAVING TIPS
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
9
6gb66001.fm5 Page 10 Tuesday, December 18, 2001 2:59 PM
BEFORE USING THE COOKING HOB
• To make the most of your new appliance,
please read the user instructions carefully and
keep them to hand for future consultation.
INSTALLATION - TECHNICAL
INFORMATION FOR THE INSTALLER
Make sure that the appliance is installed and connected to the
•
electricity supply by a qualified technician in accordance with the
manufacturer’s instructions and in compliance with local regulations.
Before installation, please read these few hints:
•
The cooktop must be installed into a worktop 30 to 40 mm thick and
•
600 mm deep.
The distance between the lower face of the cooktop and any
•
cupboard or separating panel must be of at least 30 mm.
If the cooktop is to be installed next to a column unit, leave a distance
•
of at least 50 mm.
If a hood or a cupboard is installed above the cooktop, leave a
•
minimum distance of 650 mm.
The coatings of the walls of the unit or appliances near the cooktop
•
must be heat resistant.
Do not install the cooktop near flammable materials (i.e.:curtains).
•
Installation
Cut an opening in the worktop of the dimensions shown in the
•
Product Description Sheet supplied separately.
Stretch gasket
•
overlay the junction edges.
Turn the cooktop upside down and put tabs
•
provided, tightening screws
Please make sure that the tabs are correctly positioned as illustrated.
•
Position the cooktop into the housing.
•
Put tabs
•
•
•
(A)
Tighten screw
Cut off the gasket
over the edge of the hole made being careful to
(D)
into the seats
a few turns.
(B)
into plate; tooth
until the cooktop is completely secured.
(B)
protruding from the cooktop with a sharp tool.
(D)
of the tabs should fit into the hole.
(C)
(A)
10
Loading...